LED (Light Emitting Diode)
The LED lights during charging. When the watch is placed in the charger, the LED lights to indicate that charging has started. The LED goes out when charging is completed.
Connection Pins
There are four connection pins. The two center pins are contacted with the charging terminal and water sensor of the watch, while the two outside pins are contacted with the watch case.
Locking Tab
This is used to clamp the watch to the connection pins and lock it in position.
Battery Holder (inside of the charger)
The battery holder holds 4 pcs. of size AA alkaline batteries. The battery holder is connected to the charger with a cable.
Battery Holder Cover
This battery holder cover is opened when installing or replacing the 4 pcs. of size AA alkaline batteries to install or remove the 4 pcs. of size AA alkaline batteries.
2. 4 pcs. of size AA Alkaline Batteries Installation Procedure
CAUTION Handling of Size AA Alkaline Batteries
Since improper use of the batteries can result in the risk of leakage of battery fluid or rupture, use particular caution with respect to the following items.
•Install the size AA alkaline batteries with the polarity
•Use same types of size AA alkaline batteries installed in the charger.
•Do not use fresh size AA alkaline batteries with old ones. When replacing the size AA alkaline batteries, replace all of the size AA alkaline batteries with 4 pcs. of fresh size AA alkaline batteries of the same type.
(1)Open the battery holder cover on the side of the charger. The battery holder cover can be opened by sliding in the direction of the arrow while pressing lightly on the battery holder cover.
(2)Pull out the battery holder from the charger.
(2)
(1)
Battery holder
Battery holder cover
21
