Before Using
Please make sure to adequately charge the watch using the charger provided.
This watch is rechargeable.
In addition, the watch display has been turned off prior to shipment from the factory in order to reduce power consumption by the energy storage cell of the watch.
* Remove the display seal affixed to the watch display before using the watch.
Before using, fully charge the watch by following the procedure described below. The display can then be illuminated by performing the
*Refer to the section entitled, “Charger”, for details on the procedure for installing the 4 pcs. of size AA alkaline batteries and the procedure for charging the watch.
(1) Install 4 pcs. of size AA alkaline batteries in the charger provided.
Charger
(2) Place the watch in the charger and charge the watch until the LED on top of the charger goes out. (It takes about 7 hours to fully charge the watch.)
LED
English English English English
(3)When the lower right button (A), upper right button (B), upper left button (C) and lower left button (D) are pressed simultaneously and released, an alarm tone sounds after “INITIALIZE” is displayed and the entire display is illuminated
(4)When any one of the buttons is pressed and released, the time and date are displayed after “LOADING” is displayed.
(C)(B)
(D)(A)
English English
(5)Correctly set the time, date and each mode by referring to the respective sections of the instruction manual.
*Refer to “Using the Standard Mode: 1. Using the Time Mode” of this manual for information on correcting the time and date.
3
