5. Using the Chronograph Mode
The chronograph function of this watch is able to measure time in
A. Reading the Display
[Chronograph Reset Display]
| Hours, minutes, |
(C) | (B) seconds |
| 1/100 seconds |
| Current time |
(D) 
(A)
<1/100 Second Display>
The digits for 1/100 seconds of the chronograph are only displayed for 1 minute when the chronograph is started and after returning to the measurement display from the split time display, after which they are no longer displayed. However, the 1/100 second digits are also displayed when the chronograph is stopped and during the split time display.
B. Chronograph Timing Procedure
(1)The chronograph is repeatedly started and stopped each time the upper right button
(B)is pressed once.
(2)The split time is displayed for about 10 seconds when the upper left button (C) is pressed once during measurement. The most recent split time is measured and displayed each time the upper left button (C) is pressed once. ("SPL" flashes while split time is displayed.)
(3)Pressing the upper left button (C) while the chronograph is stopped returns the watch to the reset display.
Reset
(B)
(C)
(B)
Timing |
| Stop |
|
(C)
After 10 seconds
Split time
*Split time refers to the amount of time that has elapsed from the starting line to some intermediate point.
*The watch automatically returns to the time mode when none of the buttons are pressed for about 3 minutes during the chronograph reset display.
*The watch automatically returns to the surface mode when none of the buttons are pressed for about 3 minutes in the chronograph mode (including during timing) when the surface mode has been activated (while resting on the surface).
*If the mode is switched to the low power mode during chronograph timing, chronograph timing is interrupted and the watch returns to the reset display.
40
