Programming | |
|
|
EN 38
3.Enter [9 6 3 #].
Two beeps sound after the programming key’s data is successfully copied to the control panel. A long beep indicates that the programming key is corrupt and must be erased to clear the corrupt data. Refer to Section 7.4.6 Command 964 – Erase the Programming Key on page 38 for more information.
4.Enter [9 6 0 #] to exit from Installer’s Programming Mode.
The STAY and AWAY indicators are extinguished on the remote codepad to indicate the system is disarmed.
5.Remove the programming key from the control panel.
Failure to exit from Installer’s Programming Mode before removing the programming key can corrupt the programming key.
7.4.6Command 964 – Erase the Programming Key
This command erases all data from the programming key. You can only use the CC891 Programming Key with the
To erase the programming key:
1.Enter the Installer Code (the default is 1234) and press [#] to enter Installer’s Programming Mode. Two beeps sound and the STAY and AWAY indicators flash on the remote codepad to indicate you entered Installer’s Programming Mode. The remote codepad displays the data stored in Location 000.
2.Connect the programming key to the PROGRAMMING KEY pins (next to the Auxiliary Module socket) at the top of the control panel found printed circuit board.
3.Enter [9 6 4 #].
Two beeps sound after the data is deleted.
4.Enter [9 6 0 #] to exit from Installer’s Programming Mode.
The STAY and AWAY indicators are extinguished on the remote codepad to indicate the system is disarmed.
5.Remove the programming key from the control panel.
Failure to exit from Installer’s Programming Mode before removing the programming key can corrupt the programming key.
7.4.7Command 965 – Set Up Domestic Dialing Format
Command 965 simplifies the setup of the domestic dialing format to a
To set up domestic dialing format:
1.Enter the Installer Code (the default is 1234) and press [#] to enter Installer’s Programming Mode. Two beeps sound and the STAY and AWAY indicators flash on the remote codepad to indicate you entered Installer’s Programming Mode. The remote codepad displays the data stored in Location 000.
2.Enter [9 6 5 #].
The command automatically sets Receiver 1 to domestic reporting and sets the locations shown in bold in Table 37 on page 39 for Receiver 2 only. No other locations are changed when you issue command 965.
All domestic telephone numbers are stored in Locations 550 to 597. For more information, refer to Section 9.2 Setting Up and Programming Domestic Reporting on page 43.
As shown in Table 37 on page 39, the transmission format is automatically set for domestic dialing and the Subscriber ID Number set for one identification beep. All reports, except Zone Status reporting and System Status reporting, are allocated to Receiver 1 for domestic dialing.
Zone Status Reports including Zone Bypass, Zone Trouble, Sensor Watch, and Alarm Restore codes, and System Status Reports including AUX Power Supply Fail, AC Fail, Low Battery, and Access Denied Reports are allocated to Receiver 2 and do not report unless Receiver 2 is also set up to report.
7.4.8Command 966 – Enable/Disable the Automatic Stepping of Locations
This command allows the automatic stepping of locations when programming in Installer’s Programming Mode.
Programming with the remote codepad provides no visual indication that Auto Step Mode is enabled.
To enable the automatic stepping of locations:
1.Enter the Installer Code (default = 1234) and press [#] to enter Installer’s Programming Mode. Two beeps sound and the STAY and AWAY indicators flash on the remote codepad to indicate you entered Installer’s Programming Mode. The remote codepad displays the data stored in Location 000.
2.Enter [9 6 6 #]. Two beeps sound.
To disable the automatic stepping of locations:
Enter [9 6 6 #].
Two beeps sound.
Bosch Security Systems, Inc. 12/08
