Raypak 0133-4001 manual Troubleshooting, Mechanical Problem Possible Cause Corrective Action

TROUBLESHOOTING

MECHANICAL PROBLEM	POSSIBLE CAUSE	CORRECTIVE ACTION
When heater is turned on nothing	No power to the heater………………….	Check the circuit breaker, outdoor con-
happens.		troller, etc., upstream of heater.
	Bad transformer………………………….	If power to Leads L1 and L2 of trans-
		former, but no power on 24V side, re-
		place.
	Inoperative thermostat…………………..	Jumper thermostat, replace with new if
		heater fires.
	Inoperative toggle switch………………..	If power to toggle switch, but not through
		switch, replace.
	Inoperative relay…………………………. If power to relay, but not operating, re-
		place.

Thermostat in "ON" position causes relay and pump to operate, but heater does not fire.

Main gas valve closed………………...... Open valve.

Plugged bleed line on gas valve or

gas pressure regulator………………….. Loosen bleed line and clean.

Broken pump coupler…………………… Replace coupler. Inspect bearing as-

sembly, and if frozen, lubricate or re- place.

Shutdown by low water cut-off,

caused by air…………………………….. Bleed air from system.

Gas valve defective…………………….. Check for power to gas valve. If valve has

power but will not open, check vent tube for blockage. If clear, replace valve.

Continuous shut down of manual	Temperature setting too low…………….	Reset High Limit to higher temperature.
reset High Limit.	Low water flow……………………………	Check system water pumps.
	Interrupted pump operation……………..	Check pump oil if necessary.
	Modulating control set too high………..	Reset modulator to a lower setting.
	Mechanical modulating control…………	Check and replace if necessary.

Sooting	Air starvation……………………………..
CAUTION-Soot may be combus-
tible. Wet down and exercise	Condensation…………………………….
caution when cleaning.	Toxic fumes which cause a chemical
	reaction with copper tubes or destroy
	combustion……………………………….
	Improper venting…………………………

Refer to installation instructions regard- ing combustion air requirements.

Set bypass valve to prevent heater inlet temperature from dropping below 105° F.

Remove all sources of fumes, such as freon or chloride, or isolate the heater. Follow recommended vent installation instructions.

Continuous shut down of low water	Insufficient system flow………………….	Check pumps and piping.
cut-off or flow switch.	Low water due to leaking………………..	Inspect for leaking and repair.
	Air in system……………………………...	Inspect for leakage and repair. Install an
		automatic air vent.
	Line strainer dirty…………………………	Clean.
	Lime in Heat Exchanger…………………	Ream tubes.

Low flame.

Outer jacket very hot (blistered paint)

Combustion fan not running. (If applicable)

Low gas supply………………………….. Debris in gas line (pipe dope, rocks, etc.).

Gas line too small. Improper size gas meter. Gas regulator adjustment.

Insects or debris clogging………………. Clean burners.

Burner intake ports low gas pressure…. Adjust gas pressure.

Venting or combustion air………………. Refer to installation instructions regard-

	ing combustion air requirement.
Broken refractory…..…………………….	Replace refractory panels.
Fan relay	Replace fan relay.
Fan	Loose wire connection.
	Failed fan motor.

47