Johnson Controls CSV060B-240B installation instructions Read Before Proceeding

Page 2

FORM 145.15-IOM7 (412)

IMPORTANT!

READ BEFORE PROCEEDING!

GENERAL SAFETY GUIDLINES

This equipment is a relatively complicated apparatus. During installation, operation, maintenance or service, individuals may be exposed to certain components or conditions including, but not limited to: refrigerants, oils, materials under pressure, rotating components, and both high and low voltage. Each of these items has the potential, if misused or handled improperly, to cause bodily injury or death. It is the obligation and respon- sibilty of operating/service personnel to identify and recognize these inherent hazards, protect themselves, and proceed safely in completing their tasks. Failure to comply with any of these requirements could result in serious damage to the equipment and the property in

which it is situated, as well as sever personal injury or death to themselves and people at the site.

This document is intended for use by owner-authorized operating/service personnel. It is expected that this individual possesses independent training that will en- able them to perform their assigned tasks properly and safely. It is essential that, prior to performing any task on this equipment, this individual shall have read and understood this document and any referenced materials. This individual shall also be familiar with and comply with all applicable governmental standards and regulations pertaining to the task in question.

SAFETY SYMBOLS

The following symbols are used in this document to alert the reader to areas of potential hazard.

DANGER indicates an imminently haz- ardous situation which, if not avoided, will result in death or serious injury.

WARNING indicates a potentially haz- ardous situation which, if not avoided, could result in death or serious injury.

CAUTION identifies a hazard which could lead to damage to the machine, damage to other equipment and/or environmental pollution. Usually and instruction will be given, together with a brief explanation.

NOTE is used to highlight additional in- formation which may be helpful to you.

All wiring must be in accordance with published specifications and must be performed ONLY by qualified service personnel. Johnson Controls will not be responsible for damages/problems resulting from improper connections to the controls or application of improper control signals. Failure to follow this will void the manufacturers warranty and cause serious damage to prop- erty or injury to persons.

2

JOHNSON CONTROLS

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Model CSV Vertical R-410A Read Before Proceeding Changeability of this Document CSV Operating Weight Unit Shipping Weight Lbs General InformationUnit Mounting Water PipingCSV060 Dimensional Data CSV096-120 Dimensional Data CSV180 Dimensional Data CSV240 Dimensional Data Ductwork Evaporator Blower Discharge ConversionElectrical Wiring Typical Wiring Schematic Johnson Controls Johnson Controls Johnson Controls Electrical Data Oversized Evaporator Motor Electrical Data Electrical Data Standard Evaporator MotorModel # CSV120B FAN Performance CSV060BCSV096B CSV180B CSV240BMotor and Pulley Data EVAPORATOR-STANDARD Blower Motor and Drive DataBlower Speed Adjustment Unit Flow Rate GPM Water Pressure Drop DataDrop Pressure Drop FT H20 Unit Flow Rate GPMSTART-UP and Operation UnitOperation Safety SwitchesMicroprocessor Controller Continuous BlowerCondensate Overflow Switch Safety ControlsFlash Codes Blower Evaporator CoilRefrigerant Circuits Drive Belt410A Quick Reference Guide Form 145.15-IOM7
Top Page Image Contents