GE 5200 Important Electrical Safety-ReadCarefully, Important Notes, Zoneline Components

Page 11
Important Electrical Safety—Read Carefully

Important Electrical Safety—Read Carefully

Installer: Leave these instructions with the Zoneline.

Owner: Keep these instructions for future use.

Important Notes

Follow the National Electrical Code (NEC) or local codes and ordinances.

For personal safety, this Zoneline must be prop- erly grounded.

Protective devices (fuses or circuit breakers) acceptable for Zoneline installations are speci- fied on the nameplate of each unit.

Owner: Keep these instructions for future use. CAUTION:

Do not use an extension cord with this unit.

Aluminum building wiring may present special problems—consult a qualified electrician.

When the unit is in the STOP position there is still voltage to the electrical controls.

Disconnect the power to the unit before servicing by:

1Removing the power cord (if it has one) from the wall receptacle.

or—

2 Removing the branch circuit fuses or turning the circuit breakers off at the panel.

Zoneline Components

YOU WILL NEED: • Universal power connector kit

• Phillips screwdriver

Exterior grille/louver**

Wall case**

Zoneline unit

Room cabinet*

Power supply kit**

*Shipped with the Zoneline unit

**Check the “Essential Elements” list on the unit

11

Image 11
Contents Important Electrical Safety GE Answer CenterImportant Safety Information Installation InstructionsStart Here Before using your Zoneline800.626.2000 WelcomeIMPORTANT SAFETY INFORMATION SAVE THESE INSTRUCTIONSReplacing an existing unit? READ ALL SAFETY INFORMATION BEFORE USING2Fan, Mode & Operation The controls on your ZonelineOperating Instructions 1Temp ControlVent control Energy Tips3Ventilation Control 4Air DirectionTo Remove the Room Cabinet Other Zoneline featuresAbout Your Heat Pump Operating InstructionsAuxiliary Controls Fan Switchsetting.7 1 2 3 4 5 6 7 8 9 A BCDERoom Cabinet and Case Care & CleaningOutdoor Coils Base PanOperating Tip Keeping these filters clean willTo clean the air filters Air FiltersUse the correct wall case Installation InstructionsRead carefully Replacing an Existing Unit?Zoneline Components Important Electrical Safety-ReadCarefullyYOU WILL NEED Universal power connector kit Important NotesInstallation Instructions How to Connect230/208 Volt Electrical Supply 265 Volt Electrical Supply Steps for preparing cordset for direct connectionInstallation Instructions Power Connection ChartInsulated Wall Case 1 Install the Wall Case and the Exterior Grille2 Remove the Shipping Tape from the Room Cabinet Installation Instructions 3 Install the Unit into the Wall Case4 Replace the Room Cabinet Electric Heat Option Low Voltage Connectors & Auxiliary ControlsBoost Heat Option Installation Instructions Remote Control/Wall Thermostat ClassCentral Desk Control Load Shedding All-TimeLow FanTemperature Limiting Diagnosis SwitchExplanation Things That Are NormalHelpful Information NoisePossible Causes Before You Call For ServiceProblem If Something Goes WrongBefore You Call For Service Burning Odor at the Start of Heating OperationTemperature Display Flashes Heating OperationParts and Accessories GE Service NumbersFurther Service On-SiteRepair ServiceStaple sales slip or cancelled check here What Is CoveredWhat Is Not Covered ZONELINE WARRANTY