GE 5200 The controls on your Zoneline, Operating Instructions, 1Temp Control, Mode Operation

Page 4

Operating Instructions

The controls on your Zoneline

HIGH COOL

LOW FAN

AUTO HEAT

STOP

TEMP

FAN

MODE OPERATION

1Temp Control

The temp control is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the same level of comfort.

Press the + pad to raise the temperature.

Press the – pad to lower the temperature.

2Fan, Mode & Operation

FAN—sets the fan operation for HIGH, LOW or AUTO speed. When set at AUTO, it automatically switches between LOW and HIGH as room temperature changes.

MODE—COOL—For cooling

FAN—For fan-only operation

HEAT—For heating

OPERATION—ON/STOP—Turns the unit on or off. Power remains connected to the Zoneline. The Freeze Sentinel feature still functions if switch E is “on.” See the Freeze Sentinel section.

NOTE: The temperature display will flash to indicate a possible unit malfunction. See the If Something Goes Wrong section.

Image 4

Contents GE Answer Center Important Safety InformationInstallation Instructions Important Electrical SafetyBefore using your Zoneline 800.626.2000Welcome Start HereSAVE THESE INSTRUCTIONS Replacing an existing unit?READ ALL SAFETY INFORMATION BEFORE USING IMPORTANT SAFETY INFORMATIONThe controls on your Zoneline Operating Instructions1Temp Control 2Fan, Mode & OperationEnergy Tips 3Ventilation Control4Air Direction Vent controlOther Zoneline features About Your Heat PumpOperating Instructions To Remove the Room CabinetFan Switch setting.71 2 3 4 5 6 7 8 9 A BCDE Auxiliary ControlsCare & Cleaning Outdoor CoilsBase Pan Room Cabinet and CaseKeeping these filters clean will To clean the air filtersAir Filters Operating TipInstallation Instructions Read carefullyReplacing an Existing Unit? Use the correct wall caseImportant Electrical Safety-ReadCarefully YOU WILL NEED Universal power connector kitImportant Notes Zoneline Components230/208 Volt Electrical Supply How to ConnectInstallation Instructions Steps for preparing cordset for direct connection 265 Volt Electrical SupplyPower Connection Chart Installation Instructions2 Remove the Shipping Tape from the Room Cabinet 1 Install the Wall Case and the Exterior GrilleInsulated Wall Case 4 Replace the Room Cabinet 3 Install the Unit into the Wall CaseInstallation Instructions Boost Heat Option Low Voltage Connectors & Auxiliary ControlsElectric Heat Option Remote Control/Wall Thermostat Class Central Desk Control Load SheddingAll-TimeLow Fan Installation InstructionsDiagnosis Switch Temperature LimitingThings That Are Normal Helpful InformationNoise ExplanationBefore You Call For Service ProblemIf Something Goes Wrong Possible CausesBurning Odor at the Start of Heating Operation Temperature Display FlashesHeating Operation Before You Call For ServiceGE Service Numbers Further ServiceOn-SiteRepair Service Parts and AccessoriesWhat Is Covered What Is Not CoveredZONELINE WARRANTY Staple sales slip or cancelled check here