GE 5200 Install the Wall Case and the Exterior Grille, Insulated Wall Case

Page 15

1 Install the Wall Case and the Exterior Grille

1 Install the Wall Case and the Exterior Grille

1The RAB71 or RAB77 wall case must be properly installed per instructions packed with the case.

2Remove the corrugated stiffener and the outdoor protective panel. Use the slit in the outdoor panel as a handhold and push out.

Protective	Slit
panel

Insulated Wall Case

This chassis is designed to be installed in a GE plastic or an insulated steel wall case. This minimizes condensation from forming on the room side of the case.

The RAB71 wall case is insulated. Insulation kit RAK901L is available for use with RAB77 or existing uninsulated wall cases when needed.

NOTE: For installation with a subbase or duct adaptor, see the instructions packed with those kits.

Stiffener

3Install the exterior grille from the room side following instructions packed with the grille.

2 Remove the Shipping Tape from the Room Cabinet

1Carefully remove shipping tape, if there is any, from the room cabinet and vent door.

2Remove the room cabinet by pulling it out at the bottom to release it, then lift it up to clear the rail along the unit top.

2

Shipping tape

1

15

Image 15

Contents Important Electrical Safety GE Answer CenterImportant Safety Information Installation InstructionsStart Here Before using your Zoneline800.626.2000 WelcomeIMPORTANT SAFETY INFORMATION SAVE THESE INSTRUCTIONSReplacing an existing unit? READ ALL SAFETY INFORMATION BEFORE USING2Fan, Mode & Operation The controls on your ZonelineOperating Instructions 1Temp ControlVent control Energy Tips3Ventilation Control 4Air DirectionTo Remove the Room Cabinet Other Zoneline featuresAbout Your Heat Pump Operating InstructionsAuxiliary Controls Fan Switchsetting.7 1 2 3 4 5 6 7 8 9 A BCDERoom Cabinet and Case Care & CleaningOutdoor Coils Base PanOperating Tip Keeping these filters clean willTo clean the air filters Air FiltersUse the correct wall case Installation InstructionsRead carefully Replacing an Existing Unit?Zoneline Components Important Electrical Safety-ReadCarefullyYOU WILL NEED Universal power connector kit Important NotesHow to Connect 230/208 Volt Electrical SupplyInstallation Instructions 265 Volt Electrical Supply Steps for preparing cordset for direct connectionInstallation Instructions Power Connection Chart1 Install the Wall Case and the Exterior Grille 2 Remove the Shipping Tape from the Room CabinetInsulated Wall Case 3 Install the Unit into the Wall Case 4 Replace the Room CabinetInstallation Instructions Low Voltage Connectors & Auxiliary Controls Boost Heat OptionElectric Heat Option Installation Instructions Remote Control/Wall Thermostat ClassCentral Desk Control Load Shedding All-TimeLow FanTemperature Limiting Diagnosis SwitchExplanation Things That Are NormalHelpful Information NoisePossible Causes Before You Call For ServiceProblem If Something Goes WrongBefore You Call For Service Burning Odor at the Start of Heating OperationTemperature Display Flashes Heating OperationParts and Accessories GE Service NumbersFurther Service On-SiteRepair ServiceStaple sales slip or cancelled check here What Is CoveredWhat Is Not Covered ZONELINE WARRANTY