GE 5200 installation instructions Energy Tips, 3Ventilation Control, 4Air Direction, Vent control

Page 5

Energy Tips

Keep the vent control at CLOSE. The room air will be filtered and circulated.

Set the FAN at AUTO. It switches between LOW and HIGH to adjust for room temperature changes.

Vent control

Louver screws

Remove the room cabinet and

flip the louvers to change the air direction.

OPEN

3Ventilation Control

The ventilation control lever is located at the lower left side of the Zoneline unit, behind the room cabinet.

When set at CLOSE, only the air inside the room is circulated and filtered.

When set at OPEN, some outdoor air will be drawn into the room. This will reduce the heating or cooling efficiency.

4Air Direction

To adjust the air direction, remove the room cabinet. Remove the 7 louver screws that hold the louvers in place. Flip the louver section 180°, replace the screws and the room cabinet.

Image 5

Contents Important Safety Information GE Answer CenterInstallation Instructions Important Electrical Safety800.626.2000 Before using your ZonelineWelcome Start HereReplacing an existing unit? SAVE THESE INSTRUCTIONSREAD ALL SAFETY INFORMATION BEFORE USING IMPORTANT SAFETY INFORMATIONOperating Instructions The controls on your Zoneline1Temp Control 2Fan, Mode & Operation3Ventilation Control Energy Tips4Air Direction Vent controlAbout Your Heat Pump Other Zoneline featuresOperating Instructions To Remove the Room Cabinetsetting.7 Fan Switch1 2 3 4 5 6 7 8 9 A BCDE Auxiliary ControlsOutdoor Coils Care & CleaningBase Pan Room Cabinet and CaseTo clean the air filters Keeping these filters clean willAir Filters Operating TipRead carefully Installation InstructionsReplacing an Existing Unit? Use the correct wall caseYOU WILL NEED Universal power connector kit Important Electrical Safety-ReadCarefullyImportant Notes Zoneline ComponentsInstallation Instructions How to Connect230/208 Volt Electrical Supply 265 Volt Electrical Supply Steps for preparing cordset for direct connectionInstallation Instructions Power Connection ChartInsulated Wall Case 1 Install the Wall Case and the Exterior Grille2 Remove the Shipping Tape from the Room Cabinet Installation Instructions 3 Install the Unit into the Wall Case4 Replace the Room Cabinet Electric Heat Option Low Voltage Connectors & Auxiliary ControlsBoost Heat Option Central Desk Control Load Shedding Remote Control/Wall Thermostat ClassAll-TimeLow Fan Installation InstructionsTemperature Limiting Diagnosis SwitchHelpful Information Things That Are NormalNoise ExplanationProblem Before You Call For ServiceIf Something Goes Wrong Possible CausesTemperature Display Flashes Burning Odor at the Start of Heating OperationHeating Operation Before You Call For ServiceFurther Service GE Service NumbersOn-SiteRepair Service Parts and AccessoriesWhat Is Not Covered What Is CoveredZONELINE WARRANTY Staple sales slip or cancelled check here