GE APE08 Using the portable air conditioner, Instructions, Using the Water Bucket

Instructions

Using the portable air conditioner.

Always make sure the water bucket is locked into place on the portable air conditioner.

Using the Water Bucket

Operating Instructions Safety

Make sure the drain connector is capped and in the up position. When the bucket is removed, the unit will shut off. Empty and replace the bucket, making sure that it is fully seated in the unit.

	Drain
	connector
	in up and
	capped
Water	position
	for water
bucket
	bucket use.

IMPORTANT: When using the water bucket to remove collected water, make sure that the drain connector is in the up position and that it is capped. If it is not in the up position water will drain from the connector onto the floor.

When the water bucket is full, a signal will beep and the display will show E4 until the water bucket has been emptied.

NOTE: The fan will continue to operate even when the water bucket is full. However, the Cooling or Dry mode will not work until the water bucket has been emptied and replaced correctly.

To empty the water bucket before it is full, turn the unit off and wait for three minutes for all water to collect into the bucket.

Tips Care and Cleaning

Using the Drain Hose

Water can be automatically emptied into a floor drain by uncapping the drain connector, tilting it down and connecting the drain hose. Route the drain hose straight to a floor drain.

IMPORTANT: When the drain connector is tilted down the water will drain through the connector. Make sure the hose is connected and that it is led straight to a floor drain. Never tilt the drain connector down with it capped because draining water will cause the unit to malfunction.

Tilt down
and	Cap
connect
hose to
drain.

When tilting the drain connector down, always uncap it, attach the drain hose and lead it straight to a floor drain.

How to Insert the Batteries in the Remote Control

Consumer Support Troubleshooting

1

2

3

Remove the battery cover by sliding it according to the arrow direction.

Insert new batteries, making sure that the (+) and (–) of battery are installed correctly.

Reattach the cover by sliding it back into position.

NOTES:

■Use 2 “AAA” (1.5 volt) alkaline batteries. Do not use rechargeable batteries.

■Remove the batteries from the remote control if the system is not going to be used for a long time.

6