INSTALLATION
For easy installation, select an existing light with a wall switch for replacement.
CAUTION: To Avoid Fire Or Burn Hazards:
• Allow fixture to cool before touching. The bulb and the | |
| fixture operate at high temperatures. |
• | Keep fixture at least 2" (51 mm) from combustible |
| materials. Do not aim at objects closer than 3' (1 m). |
• | Use only T4 100W (max.), G8 tungsten halogen bi- |
| pin 120 VAC lamps. |
❒The plastic hanger can be used to hold the fixture while wiring. The small end of the plastic hanger can be threaded through the hole in the center of the cover plate. The small end then goes into one of the slots on the mounting strap.
❒Route all fixture wires through the large holes in the gasket as shown.
❒Connect the junction box wires to the light fixture wires as shown. Twist together and secure with wire connectors.
For under eave installation, the sensor head must be rotated as shown in the next two steps for proper operation and to avoid the risk of electrical shock.
For eave mount only:
❒ Swing the sensor head towards the clamp
screw joint.
Controls
Clamp Screw
Black to Black Mounting
Strap
White to White
Rubber Plug
Mounting Bolt
Gasket 
❒Rotate the sensor head clockwise 180° so the controls face down.
Controls
Controls
If the sensor pops out of the ball joint, loosen the clamp screw and push the sensor back into the ball joint. Tighten the clamp screw when done.
BULB INSTALLATION.
NOTE: When
❒To remove lamp shade, loosen set screw 2 full turns with a small
❒To remove bulb, pull straight out of fixture.
❒To replace bulb, push bulb pins into lamp socket. Check that the bulb is seated properly.
❒To reinstall lamp shade, place shade on fixture and align notches on shade with tabs on fixture. Turn clockwise. Tighten set screw firmly.
WIRE THE LIGHT CONTROL.
❒Turn power off at the fuse or circuit breaker.
❒Remove the existing light fixture.
❒Install mounting strap to junction box using screws appropriate for your junction box.
Junction box ground wire to green ground screw on fixture.
MOUNT THE LIGHT CONTROL.
❒Place the Mounting Bolt through the front of the junction box cover. Push the small gasket hole over the Mounting Screw.
❒Make sure the wire connectors and wires are inside the junction box. Align the Mounting Screw with the center hole in the Mounting Strap. Secure the fixture to the Mounting Strap.
❒Push the Rubber Plug firmly into place.
❒If a wet location junction box was not used, caulk the wall plate mounting surface with silicone weather sealant.
Lamp Shade
Set Screw
Lock Nuts
Keep lamps at least 2" (51 mm) from the sensor and 2" (51 mm) from combustibles.
❒Adjust the lamp holders by loosening the lock nuts, but do not rotate the lamp holders more than 180° from the factory setting.
❒Adjust lamp shades by loosening the set screws several turns, turn shades counterclockwise and remove. Reinstall the shades in the desired posi- tion and tighten set screws.
2 |