Troubleshooting Guide

If you experience a problem, follow this guide.

SYMPTOM	POSSIBLE CAUSE

Lights will	1.	Light switch is turned off.
not come	2.	Light is loose or burned out.
on.	3.	Fuse is blown or circuit breaker is turned
		off.
	4.	Daylight turnoff is in effect (recheck
		after dark).
	5.	Incorrect circuit wiring, if this is a new
		installation.
	6.	Re-aim the sensor to cover desired area.

Lights come	1.	Light Control may be installed in a
on in		relatively dark location.
daylight.	2.	Light Control is in Test. (Set control
		switch to an ON-TIME position).
Lights come	1.	Light Control may be sensing small
on for no		animals or automobile traffic (re-aim
apparent		sensor).
reason.	2.	Range is set too high. (Reduce Range
		setting).
	3.	Dual Brite™ Timer is on.

Lights turn	1.	Sensor is in a relatively dark location.
off too late		(Relocate sensor, or use 3 hr or 6 hr
in Dusk-to-		setting).
Dawn
setting.

SYMPTOM	POSSIBLE CAUSE

Lights stay	1.	A lamp is positioned too close to the
on continu-		sensor or pointed at nearby objects
ously.		that cause heat to trigger the sensor.
		(Reposition the lamp away from the
		sensor or nearby objects).
	2.	Light Control is pointed toward a heat
		source like an air vent, dryer vent, or
		brightly-painted heat-reflective surface.
		(Reposition sensor. Reduce Range).
	3.	Light Control is in Manual Mode.
		(Switch to Auto).

Lights flash	1.	Heat or light from the lamps may be
on and off.		turning the Light Control on and off.
		(Reposition the lamps away from the
		sensor).
	2.	Heat being reflected from other ob-
		jects may be affecting the sensor.
		(Reposition sensor).
	3.	Light Control is in the Test mode and
		warming up. (Flashing is normal un-
		der these conditions. Turn Boost off).

Lights flash	1.	Sensor is detecting its own lights.
once, then		(Reposition lamps to keep area be-
stay off in		low the sensor relatively dark).
Manual Mode.

4	598-1038-03