Panasonic CQ-5330U operating instructions Radio

Page 20

Troubleshooting (Continued)

❐Radio

Trouble

Much noise in FM stereo and monaural broad- casts.

Preset station is reset.

Cause/Step

Station is too far, or signals are too weak.

aSelect other stations of higher signal level.

The radio antenna is not extended enough.

aExtend fully the radio antenna.

Battery cable is not correctly connected.

aConnect the battery cable to the terminal that is always active.

❐CD

Trouble

Disc is in the CD compartment but no sound is made, or disc is ejected automatically.

Sound skips, bad sound quality. (e.g. caused by noise)

20

Cause/Step

Disc is upside down.

aPlace disc in the correct direction with the label side up.

•Disc is dirty.

•Disc has scratches.

aClean disc, referring to the section on “Notes on Discs”.

A disc that has data other than CD-DA type is loaded.

aDiscs that have CD-DA type data should be used.

aThe unit may not successfully playback a CD-R/RW that is made in combination of writing software, a CD recorder (CD-R/RW drive) and a disc which are incompatible one another. Refer to instructions for the concerned devices for details.

•Disc is dirty.

•Disc has scratches.

aClean disc, referring to the section on “Notes on Discs”.

aThe unit may not successfully playback a CD-R/RW that is made in combination of writing software, a CD recorder (CD-R/RW drive) and a disc which are incompatible one another. Refer to instructions for the concerned devices for details.

CQ-5330U

Page 19 Page 21
Image 20
Page 19 Page 21
Contents
CQ-5330U Safety Information Following applies only in the U.S.ALaser Products Wave length 780 nm FCC WarningWhen Driving When Washing Your CarUse Authorized Servicenters When ParkedContents Power and Sound Controls PowerRemote Control Signal Sensor Power on Press PWR powerIllumination Switching BassTreble BalanceClock Setting Time ResetSelecting the Clock Display Initial TimeAlarm Time Setting Initial Alarm TimeAlarm Operation Alarm output Volume SelectionRadio Radio Preset Station Setting Auto Preset Memory APMManual Preset Memory Preset Station CallingTuning in a Weather Band Station Weather Band StationsCD Player Disc Insert and Playback Disc insertStop and Disc Eject Listening to a CDTrack Selection Track Search Repeat play Random play Scan playCD Changer mode CD Changer ControlDisc Selection Track SelectionRemote Control Scan Play Tracks DiscsRepeat Play Tracks Discs Random Play Tracks Discs XM Mode XM Control Channel Scan Channel SelectionManual Preset Memory Select a band Press 1 toPress and hold Mode Disp for more than 2 seconds XM ID is or communication fails, Press Mode to another modeCommon TroubleshootingPreliminary Steps Radio Sound Setting XM ControlError Display Messages CD changerCheck the disc Select the next available compact disc. Check the discCare of the Unit MaintenanceCleaning this Unit Speaker Connections Product ServicingWrong ChassisOverview Installation GuideDashboard Specifications Installation Dashboard InstallationInstallation Hardware Using the rubber cushion optionMounting springs C ExampleTabTo Remove the Unit from the vehicles dashboard Insert each Removal Tool i and pull Removal Tool U-shapedCD Receiver Wiring DiagramElectrical Connections XM ANT APM/ PRG Disp VOL Seek Tune Band Mode Specifications GeneralFM Stereo Radio AM RadioMemo Memo One Panasonic Way, Secaucus New Jersey
Top Page Image Contents