Pelco C3468M Important Notices, Legal Notice, Regulatory Notices, Open Source Software Notice

Page 6

Important Notices

LEGAL NOTICE

SOME PELCO EQUIPMENT CONTAINS, AND THE SOFTWARE ENABLES, AUDIO/VISUAL AND RECORDING CAPABILITIES, THE IMPROPER USE OF WHICH MAY SUBJECT YOU TO CIVIL AND CRIMINAL PENALTIES. APPLICABLE LAWS REGARDING THE USE OF SUCH CAPABILITIES VARY BETWEEN JURISDICTIONS AND MAY REQUIRE, AMONG OTHER THINGS, EXPRESS WRITTEN CONSENT FROM RECORDED SUBJECTS.

YOU ARE SOLELY RESPONSIBLE FOR INSURING STRICT COMPLIANCE WITH SUCH LAWS AND FOR STRICT ADHERENCE TO ANY/ALL RIGHTS OF PRIVACY AND PERSONALTY. USE OF THIS EQUIPMENT AND/OR SOFTWARE FOR ILLEGAL SURVEILLANCE OR MONITORING SHALL BE DEEMED UNAUTHORIZED USE IN VIOLATION OF THE END USER SOFTWARE AGREEMENT AND RESULT IN THE IMMEDIATE TERMINATION OF YOUR LICENSE RIGHTS THEREUNDER.

REGULATORY NOTICES

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RADIO AND TELEVISION INTERFERENCE

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

You may also find helpful the following booklet, prepared by the FCC: “How to Identify and Resolve Radio-TV Interference Problems.” This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402.

Changes and modifications not expressly approved by the manufacturer or registrant of this equipment can void your authority to operate this equipment under Federal Communications Commission’s rules.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

OPEN SOURCE SOFTWARE NOTICE

This product includes certain open source or other software originated from third parties that is subject to the GNU General Public License (GPL), GNU Library/Lesser General Public License (LGPL) and different and/or additional copyright licenses, disclaimers and notices.

The exact terms of GPL, LGPL and some other licenses are provided to you with this product. Please refer to the exact terms of the GPL and LGPL at www.fsf.org (Free Software Foundation) and www.opensource.org (Open Source Initiative) regarding your rights under said license. You may obtain a complete corresponding machine-readable copy of the source code of such software under the GPL or LGPL by sending your request to digitalsupport@pelco.com and the subject line should read Source Code Request. You will then receive a link in the e-mail for you to download the source code.

This offer is valid for a period of three (3) years from the date of the distribution of this product by Pelco.

6

C3468M (4/10)

Image 6
Contents Spectra IV IP Series SD4E Dome System Page Contents List of Illustrations List of Tables Regulatory Notices Important NoticesLegal Notice Open Source Software NoticeParts List DescriptionModels Prepare the ceiling refer to Figure MountingIN-CEILING Cut out the circlePrepare the ceiling refer to on HEAVY-DUTY IN-CEILINGTighten the screws until you hear a clicking noise Prepare the holesInstalling the Heavy-Duty In-Ceiling Back Box PENDANT, HEAVY-DUTY PENDANT, and Stainless Steel Attaching the Pendant Back Box to the MountWiring Back Box DoorBack Box Circuit Board Connect the Wiring to the Circuit Board Microphone Line-Out Audio Twisted Pair Cable Amplifier Line-In Audio Twisted Pair Cable SpeakerClose the interconnect door and snap the tab lock into place Table A. Video Coaxial Cable Requirements Cable requirements Ohm impedance All-copper center conductorInstalling the Dome Drive Installing the Lower Dome HEAVY-DUTY IN-CEILING Pendant Attach the back box leash to the lower dome refer to FigureHEAVY-DUTY Pendant Attach the back box leash to the lower dome refer to onC3468M 4/10 Stainless Steel Installing the Stainless Steel Lower Dome Troubleshooting Have built-in echo Cancellation Table C. Troubleshooting the Spectra IV IP Dome System 2Lower the speaker volume Audio is received Too highSwitch Settings Table E. Switch Settings for SW1, Pelco P-Type Control Switch SettingTable F. Switch Settings for SW1, Pelco D-Type Control Switch Setting Switch Setting Switch Setting Switch Setting Switch Setting 243 244 245 246 247 248 249 250 251 252 253 254 Specifications ElectricalAudio Hours after power-up IN-CEILINGMinimum HEAVY-DUTY IN-CEILING Pendant HEAVY-DUTY Pendant Construction Back Box Power-upStainless Steel Dome Drive Aluminum, thermoplastic Lower Dome Trim RingProduct Warranty and Return Information

C3468M specifications

The Pelco C3468M is a sophisticated surveillance camera designed to meet the growing demands of modern security applications. Known for its exceptional image quality and advanced technologies, this camera is an ideal choice for both indoor and outdoor environments.

One of the main features of the C3468M is its high-definition resolution. It delivers stunning 4MP video quality, ensuring that every detail is captured with precision. This clarity becomes invaluable in critical situations where identifying faces or license plates is essential. The camera utilizes advanced imaging technologies, such as Wide Dynamic Range (WDR), which helps balance lighting conditions in complex environments. This means it can effectively capture scenes with both bright and dark areas, making it suitable for diverse lighting situations.

Another notable characteristic of the C3468M is its innovative low-light performance. The camera is equipped with a high-sensitivity sensor, allowing it to produce clear images even in challenging low-light conditions. This is particularly important for surveillance during nighttime or in dimly lit areas, providing round-the-clock monitoring without compromising image clarity.

The C3468M also boasts robust environmental resilience. With an IP66 rating, this camera is protected against dust and water, making it suitable for outdoor applications in various weather conditions. Additionally, it features an IK10 rating for impact resistance, ensuring that it can withstand physical impact and tampering, which is essential for maintaining security in vulnerable locations.

Moreover, the C3468M incorporates advanced video analytics capabilities. Features such as motion detection, tampering detection, and line crossing can be configured to trigger alerts, enhancing situational awareness. These smart capabilities help security personnel respond more effectively to incidents, streamlining vigilance efforts.

The camera is user-friendly, with seamless integration into existing security systems. It supports various connectivity options, including IP networking, allowing for flexible installation and remote access for monitoring. The Pelco C3468M highlights a commitment to security innovation, providing professionals with the tools needed to create safer environments. With its blend of high-performance features and cutting-edge technology, this camera is a reliable choice for comprehensive surveillance solutions.