Pelco ES30TI manual Limit Stops Menu, Clear Manual Stops, Presets

Limit Stops Menu

To program manual limit stops using the Limit Stops menu:

1.Program preset 95 (28). The main menu appears.

2.Position the cursor (>) beside <Limit Stops>. Press the Iris Open button; the menu appears.

3.Position the cursor (>) beside Set Man Limits. Press the Iris Open button. The message PRESS IRIS OPEN TO SET LEFT LIMIT appears.

4.Push the joystick left until the camera reaches the leftmost limit, or position, for the camera.

5.Press the Iris Open button. This is the left manual limit. The message PRESS IRIS OPEN TO SET RIGHT LIMIT appears.

6.Push the joystick right until the camera reaches the rightmost limit, or position, for the camera.

7.Press the Iris Open button. This is the right manual limit.

8.Exit the Limit Stops menu.

Clear Manual Stops

To clear the manual limit stops:

1.Program preset 95 (28). The main menu appears.

2.Position the cursor (>) beside <Limit Stops>. Press the Iris Open button; the menu appears.

3.Position the cursor (>) beside Clear Man Limits. Press the Iris Open button; the cursor briefly changes to an asterisk (*) to show that the limit stops have been disabled.

Scan Limit Stops

Use scan limit stops to reverse the pan operation when the unit reaches a limit stop during random, frame, or auto scanning. Scan limit stops can be set using controller presets or using the Limit Stops menu.

Presets

NOTE: Before using controller presets, refer to the documentation for your control system for information about programming presets. To program scan limit stops using controller presets:

1.Enable limit stops (refer to Turning Limit Stops On or Off on page 32) and exit the menu.

2.Push the joystick left until the camera reaches the leftmost limit, or position, for the camera.

3.Program preset 92 (25). This is the left scan limit.

4.Push the joystick right until the camera reaches the rightmost limit, or position, for the camera.

5.Program preset 93 (26). This is the right scan limit.

If you set presets 92 (25) and 93 (26) to the same point, the camera disables scan limit stops.

When you program preset 92 (25), the scan limit stops are disabled until you program preset 93 (26).

C1307M-C (8/07) 33