FUNCTIONS | NAMES AND |
CONNECTIONS | BASIC |
OPERATION | BASIC |
CONNECTIONS | ADVANCED |
SETUP | |
OPERATION | ADVANCED |
TROUBLESHOOTING | |
OTHERS |
ENGLISH
ADVANCED OPERATION
CHECKING THE CODE
1. | 2. |
| |
| 3. |
1. | 4. |
|
1. Press and hold down the SOURCE button for appliance which should be controlled and press SET button until the indicator blinking twice then back light flushes.
2. Press the INFO button.
The indicator will blink twice.
3. To setup code for all digits is displayed on the LCD in 3 seconds.
RESETTING THE CODE
1.
1.
2.
1. Press and hold down the SOURCE button for appliance which should be controlled and press SET button until the indicator blinking twice.
Then back light flushes.
2. Press the below codes to reset. TV : 1000
DVD : 2000
CD : 3000
DSS : 4000
BD : 5000
Note
After this procedure, the selected SOURCE button is set initial code.
LEARN MODE
This remote controller is capable of learning and storing codes used by other remote controls that you already own.
For codes which are not learned, the remote controller will transmit either the Marantz preset codes from the initial settings, or remote codes from another manufacturer’s AV equipment which is set by the customer.
The receiver sensor for the remote controller signals is located at the top of the remote controller.
Notes
•This remote controller is capable to learn around 160 codes.
•When the batteries are getting weak , the learning procedure is not successful.
LEARNING PROCEDURE
1. Place the remote controller so that its infrared signal transmitter is facing the infrared signal receiver on the Marantz remote controller at a distance of about 5 cm (2 inches).
2. Press and hold down the SET and SETUP buttons until LEARN indicator blinks.
3. Select the SOURCE button to select the SOURCE, the SOURCE name is displayed on the LCD.
4. Select the button to be learned.
• LEARN indicator stop to blink.
Notes
•The learning function is unavailable for all SOURCE buttons and HDMI button in any mode.
•The learning function is unavailable for all buttons in TUNER mode, USB mode,
5. Press and hold the button of the original remote controller to learn until “OK” is displayed on the LCD.
•When “NG” is displayed on the LCD, repeat this step.
•When the memory of the remote controller is full, “FULL” is displayed on the LCD. If you want to learn the code, you should erase other learned button.
6.Repeat steps 4 and 5 to learn other buttons in same SOURCE.
7.Repeat steps 3 to 6 to learn other
SOURCE.
70