PRESET SCAN
1.
5.
2.
3. 6.
1. Press the TUNE button twice within two seconds on the remote controller.
2. Press the BAND button to select XM band.
3. Press the P.SCAN button on the remote controller.
4. Preset channels are recalled in sequence (No.1 → No.2 → etc.) for about 10 seconds each. The time changes by the received condition. No stored preset number will be skipped.
5. Pressing the 2 button during prescanning speeds up scanning.
Also, pressing the 1 button returns to the previous preset channel.
6. When the desired preset channel is received, cancel the preset scan operation by press the P. SCAN button.
CLEARING STORED PRESET CHANNELS
You can remove preset channels from the memory using the following procedure.
2. 3.
2.
3.
1. Recall the preset number to be cleared with the method described in “PRESET SEARCH MODE”.
2. Press the MEMORY button on the front panel or press the MEMO button on the remote controller.
3. The stored preset number blinks in the display for 5 seconds. WhiIe blinking, press the CLEAR button on the front panel or CLR button on the remote controller.
4. “xx CLEAR” appears on the dispIay to indicate that the specified preset number has been cleared.
Notes
•To clear all stored preset channel, press and hold the T.MODE and the ENTER buttons on the unit for two seconds.
•There are 50 preset channels prepared at the factory default. The 50 channels are all set to “CHANNEL 001”. Each channel can be stored in the preset memory. You can search for only the preset channels.
LISTENING TO
SIRIUS SATELLITE RADIO
SELECTING AN INPUT SOURCE
Before you can listen to SIRIUS Satellite Radio, you must first select the input source on the unit.
1.2.
1.
2.
(Using the unit)
1. Turn the INPUT SELECTOR knob to select “TUNER”.
2. Press the BAND button to select SIRIUS.
(Using the remote controller)
1. To select tuner, press the TUNE button twice within two seconds on the remote controller.
2. Press the BAND button to select SIRIUS.
ENGLISH
ADVANCED OPERATION
CHECKING THE SIRIUS SIGNAL
STRENGTH AND RADIO ID
1.
2.
1. Press the TUNE button on the remote controller.
2. Press the T.DISP button 3 times to display the signal status on the front display of the unit.
S R S A T :
S R T E R R :
•The top line of the display shows the strength of the signal received from satellite, while the bottom line displays the strength of the terrestrial signal received.
•An mark indicates the strength of the stronger of the satellite and terrestrial signals.
•The display changes as shown below according to the receiving condition.
EXCELENT display
S R | : |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
GOOD display
S R | : |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
WEAK display
S R | : |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
NO SIGNAL display
S R | : |
|
|
NAMES AND | FUNCTIONS |
BASIC | CONNECTIONS |
BASIC | OPERATION |
ADVANCED | CONNECTIONS |
SETUP | |
ADVANCED | OPERATION |
TROUBLESHOOTING | |
OTHERS |
51