Marantz SR6004 REMOTE CONTROLLER BASIC OPERATION, Preset Mode, Scanning The Code Table, Basic

SR6004 REMOTE CONTROLLER

BASIC OPERATION

PRESET MODE

(Whenoperatingnon-MarantzAVequipment products)

PROGRAMMING WITH THE 4-DIGIT CODE

ENGLISH

ADVANCED OPERATION

SCANNING THE CODE TABLE

2.

NAMES AND FUNCTIONS

NORMAL MODE

(When operating Marantz AV equipment products)

This remote controller is preset with remote control codes from AV equipment by other manufacturers. The preset codes are TV, CD, DVD and DSS. Settings can be made in one of two ways.

1.

1.

2.

3.

2.

BASIC CONNECTIONS

This remote controller is preset with a total of 12 types of remote codes, including Marantz BD, DVD, VCR (VCR deck), DSS (Satellite broadcasting tuner), TV (Television), CD, CDR, AUX, TUNER, USB, M-XP and AMP mode.

Learning is not necessary for Marantz products. You can use these products without setting any codes.

1. Press the SOURCE button. For this example, press DVD.

Pressing the SOURCE button once changes the remote control to the settings for the source that was pressed.

To change the amplifier on other source, press the SOURCE button twice (double- click). The code is sent, and then the amplifier source changes to DVD.

SETTING THE BACK LIGHT

Pressing the Light button located on the side of the remote controller lights the remote controller’s backlight. Pressing the button again while the backlight is lit lights the backlight for another 2 seconds.

To turn off back light, press and hold down the SET and OFF button untilindicator blinks twice.

To turn on it again, press and hold down the SET and ON button untilindicator blinks twice.

Initial is back light ON.

When the preset codes are set, the following codes are contained in the source button of the remote controller.

See the attached manufacturer number list for the preset manufacturers, devices, preset numbers, and other settings.

Remote	Corresponding
controller		Device name
	preset code
source name
TV	TV	Television
DVD	DVD	DVD player
CD	CD	CD player
		Satellite
DSS	SATELLITE	broadcasting
		tuner equipment
BD	BD	Blu-ray disc player

Importants

•Some codes may be not match your equipment. In this case, you can use LEARN mode to store these codes.

•The preset codes do not cover full functions.

If you need extra function, use LEARN mode to store extra function.

•When the batteries are getting weak, the preset procedure is not successful.

1. Press and hold down the SOURCE button for the appliance which should be controlled and press SET button until the indicator blinks twice. Then back light flushes.

2. Press the 4-digit code by numeric buttons for appliance (code table at the end of this book)

Display 4-digit code on the LCD.

When the procedure is successful, “OK” is displayed on the LCD.

Note

If “NG” is displayed on the LCD, then repeat steps 1 through 2 and try entering the same code again.

3.

5.

1. Switch on the appliance which should be controlled.

2. Press and hold down the SOURCE button for appliance which should be controlled and press SET button until the indicator blinking twice. Then back light flushes.

3. Aim the remote control at the appliance and slowly alternate between pressing INPUT 3 button and the SOURCE ON/OFF button for the appliance.

Display the setup number on the LCD.

4. Stop when the appliance turns off.

5. Press ENTER button once to lock in the code.

BASIC	OPERATION
ADVANCED	CONNECTIONS
SETUP
ADVANCED	OPERATION
TROUBLESHOOTING
OTHERS

69