American Standard 7024 Install POP-UP Drain, Install Black Gasket, Install Gray Locknut

2 INSTALL POP-UP DRAIN	Fig. A.		Fig. B.	REAR OF
				SINK
Remove CLEAR PLASTIC COVER (1). Remove	1
CARDBOARD SPACER (2) from under DRAIN
POP-UP (3). Fig. A.	3
Drop DRAIN BODY (4) through sink drain			4	6
hole. Make sure WHITE FOAM GASKET (5)			5
is under flange of DRAIN BODY (4). Fig. B.
Note: No plumber’s putty or caulk is required.	2			SINK
				DRAIN
The CABLE ATTACHMENT POINT (6) must				HOLE
face towards the rear of the SINK. Fig. B.
3 INSTALL BLACK GASKET
Install BLACK CONE GASKET (1) onto DRAIN BODY (2)
from below.
Note: The flat side of the BLACK CONE GASKET (1) must
face down.			2
			1
			FLAT SIDE OF GASKET
			MUST FACE DOWN
4 INSTALL GRAY LOCKNUT	Fig. A.		Fig. B.
Install GRAY LOCKNUT (1) onto DRAIN BODY (2)
from below SINK. Fig. A.
Note: The flat side of the GRAY LOCKNUT (1)
must face up.		2
Tighten firmly by hand. No tools are required.				DRAIN
Check DRAIN FLANGE in SINK to ensure that
			FLAT SIDE OF	FLANGE
WHITE FOAM GASKET (3) is fully compressed
and not visible. Fig. B.			GRAY LOCKNUT
			MUST FACE UP
		1	3	WHITE FOAM
				GASKET
				NOT VISIBLE

5POP-UP KNOB

POP-UP KNOB (1) must be fully down.

1

M968867 Rev. 1 . 1

2