American Standard 7038 Install POP-UP Drain, Install Black Gasket, Install Gray Locknut

2	INSTALL POP-UP DRAIN	Fig. A.		Fig. B.	REAR OF
	Remove CLEAR PLASTIC COVER (1). Remove				SINK
		1
	CARDBOARD SPACER (2) from under DRAIN
	POP-UP (3). Fig. A.	3			4
	Drop DRAIN BODY (4) through sink drain
					6
	hole. Make sure WHITE FOAM GASKET (5)
				5
	is under flange of DRAIN BODY (4). Fig. B.
	Note: No plumber’s putty or caulk is required.	2			SINK
					DRAIN
	The CABLE ATTACHMENT POINT (6) must				HOLE
	face towards the rear of the SINK. Fig. B.
3 INSTALL BLACK GASKET
	Install BLACK CONE GASKET (1) onto DRAIN BODY (2)
	from below.
	Note: The flat side of the BLACK CONE GASKET (1) must
	face down.			2
				1
					FLAT SIDE OF GASKET
					MUST FACE DOWN
4 INSTALL GRAY LOCKNUT		Fig. A.			Fig. B.
	Install GRAY LOCKNUT (1) onto DRAIN BODY (2)
	from below SINK. Fig. A.
	Note: The flat side of the GRAY LOCKNUT (1)
	must face up.		2
	Tighten firmly by hand. No tools are required.				DRAIN
	Check DRAIN FLANGE in SINK to ensure that			FLAT SIDE OF	FLANGE
	WHITE FOAM GASKET (3) is fully compressed
	and not visible. Fig. B.			GRAY LOCKNUT
				MUST FACE UP
			1		3 WHITE FOAM
					GASKET
					NOT VISIBLE
5 POP-UP KNOB					DOWN

POP-UP KNOB (1) must be fully down.

1

M968868 Rev 1 . 2

2