INSTALLATION INSTRUCTIONS
INSTALLATION
6.2Locate the rear panel against the spacer brackets and slide down so that it locates on the ledge of the flame baffle, see diagram 6.
6
AR0360
6.3Locate the front coal between the heat shield and flame baffle so that its ends sit flat against the burner skin, see diagram 7.
7
AR0361
6.4Place five of the loose round coals on the front coal so that they lean against the flame baffle, in between the fingers. Place the two rectangular coals behind the round coals, one at each side, see diagram 8.
8
6.5Place four of the loose round coals behind the first row so that they sit on the fingers, the two outer coals should touch the rectangular coals, see diagram 9.
9
AR0363
6.6Place the remaining three round coals behind the centre row so that they touch the back panel, see diagram 10.
10
AR0364
6.7Ensure that the fibreglass seal on the back of the door is intact, locate the door on the four studs and slide back to the firebox. Secure in place using the four brass nuts and the tool supplied, do not over tighten the nuts, see diagram 11. Keep the tool with these instructions for future use.
11
AR0362
AR0390
NEVER OPERATE THE STOVE WHEN THE DOOR IS
REMOVED OR WHEN THE GLASS IS BROKEN.
14