INSTALLATION INSTRUCTIONS
INSTALLATION
Large Marlborough
6.14Place the flame baffle onto the shelf at the rear of the tray and push up against the rear ledge, see diagram 18.
18
AR0370
6.15Locate the front coal moulding in front of the flame baffle ensuring that the end legs sit flat against the burner skin, see diagram 19.
19
AR0371
6.16Place three large coals on the front coal so that they lean against the flame baffle and four large coals on the flame baffle so that they sit on the fingers, see diagram 20.
20
6.17Place three small coals at each end of the front coal so that they lean against the flame baffle and a further four large coals on the flame baffle, two at each end, see diagram 21.
21
AR0373
6.18Place six small coals along the rear of the flame baffle, resting against the rear ledge, see diagram 22.
22
AR0374
NOTE: ENSURE THAT THE COALS ARE POSITIONED, AS DETAILED ABOVE. ONLY USE THE CORRECT AMOUNT OF COALS, AS SPECIFIED IN DIAGRAMS.
6.19Ensure that the fibreglass seal on the back of the door is intact, locate the door on the four studs and slide back to the firebox. Secure in place using the four brass nuts and the tool supplied, do not over tighten the nuts, see diagram 23. Keep the tool with these instructions for future use.
23
AR0372
AR0390
NEVER OPERATE THE STOVE WHEN THE DOOR IS REMOVED OR WHEN THE GLASS IS BROKEN.
16