KitchenAid 8302472A installation instructions Parts supplied for installation, Product dimensions

Page 3

Parts supplied for installation

1-3/4"

(4.4 cm)

1"

(2.5 cm)

2 - #10 x 2"

anti-tip

phillips head screws

brackets

 

 

Anti-tip bracket must be securely

attached to a wall stud. Thickness of

finished wall may require using

longer screws to anchor the

bracket.

• L.P. conversion kit is included in

literature package.

• Backguard and island trim. The

backguard included with the range

must be installed when a standard

24” (61 cm) deep base cabinet is

used and there is zero clearance

between the back edge of range

and combustible rear wall.

For island installations or other

installations with more than 7"

(17.8 cm) clearance to back wall, use

the optional stainless steel island

trim, included with the range, to

NOTE:

 

regulator

48" (121.9 cm)

located at

cooktop width

center bottom

 

of range.

 

13-1/2"

 

(34.3 cm)

 

1/4" (6.4 mm)

spacer

26-1/2" (67.3 cm)

width with

control panel

Product dimensions

49-1/2"

(125.7 cm)

overall height

36" (91.4 cm)

cooktop

height with

feet

loosened 3/4 turns

48" (121.9 cm)

width

48" (121.9 cm) range with all sealed burners shown

cover the backguard mounting

flanges.

Cabinet opening dimensions

13" (33 cm) max.

upper cabinet depth 48" (121.9 cm) min. upper cabinet width

For minimum clearance to top of range, see NOTE.*

18" (45.7 cm) upper cabinet to countertop

*NOTE: 49" (124.5 cm) min. when bottom of wood or metal cabinet is protected by not less than 1/4" (6.4 mm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015"

(0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.

55" (139.7 cm) min. clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.

48-1/4" (122.6 cm)

opening width

40"

(101.6 cm)

4"

 

12" (30.5 cm) min.

 

clearance from both

 

sides of range to side

 

wall or other

 

combustible material

 

above cooking surface

 

 

0" (0 cm) clearance from

 

both sides and back of

 

range to adjacent

8"

combustible construction

(20.3 cm)

below cooking surface

 

 

3" (7.6 cm) maximum gas line height

gas line opening to be located in this area

5-1/2" (14 cm)

3-1/2" (8.9 cm) maximum junction

box height

junction box to be located in this area

(10.2 cm)

12"

20"

(30.5 cm)

(50.8 cm)

 

3

Image 3
Contents Read and save these instructions Installation InstructionsBefore you start Your safety and the safety of others are very importantProduct dimensions Parts supplied for installationGas supply requirements Electrical requirements InstallationUngrounded neutral Grounded neutralFront screws Rear screws required But not shown Electronic Ignition System initial lighting Check the operation of the surface burnersIf you need assistance Installer checkoff listMaintenance If you need serviceResettable Cooktop schematic Oven schematicImportant Lire et conserver ces instructions Deux combustiblesAvant de commencer ’installation Pièces fournies pour DimensionsDimensions de l’espace d’installation GAZ Naturel Alimentation en gazAlimentation électrique Conducteur neutre relié La terre Conducteur neutre non relié La terreSystème d’allumage électronique allumage initial Si la cuisinière ne fonctionne pas Liste de contrôle de l’installateurEntretien Si vous avez besoin de services de réparationSchéma du four Schéma de la table de cuisson