Grounded neutral, Ungrounded neutral | KitchenAid 8302472A instruction

WARNING WARNING

3.	Connect the two black wires
	together; and the two red wires
	together using twist-on connectors.
	(See Figure 1.)
4.	Connect the two white wires
	together using twist-on connector.
5.	Connect the bare or green ground
	wire from the range cable to the

Tip Over Hazard

A child or adult can tip the range and be killed.

Connect anti-tip bracket to rear range foot.

Reconnect the anti-tip bracket, if the range is moved.

Failure to follow these instructions can result in death or serious burns to children and adults.

line	wall stud

anti-tip

bracket mounting screws

6. Position top of anti-tip bracket at line marked in step 5 and mark holes. Drill two 1/8" (3 mm) holes. Use screws provided to fasten anti-tip bracket to wall.

NOTE: Anti-tip bracket must be mounted securely to stud in wall behind the range. Depending on thickness of the wall covering, longer screws may be required.

7. Make electrical connection.

If your house has aluminum wiring, see “Electrical requirements” page 5.

Electrical Shock Hazard

Disconnect power before servicing.

Use 8 gauge copper wire.

Electrically ground range.

Failure to follow these instructions can result in death, fire, or electrical shock.

This range must be connected to a grounded, metallic permanent wiring system or a ground connector should be connected to the ground terminal or wire lead on the range.

This range is manufactured with a frame- connected, bare or green ground wire. Connect the range cable to the junction box through the U.L.- or CSA-listed conduit connector. Complete electrical connection according to local codes and ordinances.

7A.Where local codes do not permit connecting the frame-ground conductor to the neutral (white) junction box wire (also used for Canadian installations):

4-wire cable from power supply

	junction box
red wires	junction box
red wires



		white wires

twist-on connector

bare or green	black wires
wires
wires

grounded wire in the junction box or

other grounded connector using

twist-on connector. (See Figure 1.)

Do not connect bare ground wire to

neutral (white) wire in junction box.

7B. Where local codes permit connecting the frame-ground conductor to the neutral (white) junction box wire (not used for Canadian installations):

	3-wire cable from
junction	power supply
box
		black
red		wires
wires
white
wire
white and bare
or green wires
		U.L.- or CSA-
		listed conduit
4-wire cable from range		connector

Grounded neutral

Figure 2

1. Disconnect power.
2.	Connect the flexible, armored cable
	from the range to the junction box
	using a U.L.- or CSA-listed conduit
	connector. Tighten screws on conduit
	connector.
3.	Connect the two black wires together;

4-wire cable from range

U.L.- or CSA- listed conduit connector

the two red wires together; and the

bare or green and white cooktop cable

wires to the white (neutral) wire in the

Ungrounded neutral

Figure 1

1.Disconnect power.

2.Connect the flexible, armored cable from the range to the junction box using a U.L.- or CSA-listed conduit connector. Tighten screws on conduit connector.

junction box using twist-on

connectors. (See Figure 2.)