LOREX Technology QLR1660 Pan/Tilt/Zoom, Control buttons, Color Control, Buttons, Volume Control

QLR1660 User Manual

■ Shutdown button	Click this button to shutdown the main server application.
	[NOTE] The default ID and password of administrator are ‘admin’ and ‘master’
■ Relay On buttons	If you click ‘RELAY’ tap, the relay on buttons appear.

-Clicking these buttons will activate the corresponding external relay outputs.

(Refer to ‘SECTION 3-2-6. Speaker, Relay out Setup’ and ‘Appendix-2. External Sensor and Relay Installation’.)

■ Pan/Tilt/Zoom	If you click ‘PTZ’ tap, the Pan/Tilt/Zoom control buttons appear.
Control buttons	- The following controls are available:
	▪ Camera Selection to control Pan/Tilt/Zoom/Focus
	▪ Tilt up/down (▲/▼)
	▪ Pan left/right (◄/►)
	▪ Zoom in/out (+/-)
	▪ Focus in/out (+/-)
	▪ Auxiliary (1,2,3)
	(Refer to ‘Appendix -1.Pan/Tilt/Zoom Camera Installation’.)
■ Color Control	Clicking the ‘Color’ tab brings up the picture adjustment controls.
buttons	.
	- You are able to control the brightness, contrast, hue and saturation of
	the video image.

■Audio Speaker(On/Off) Use for full-duplex audio communication with the QLR1660 Client system.

/ Volume Control	- Clicking the speaker button enables you to listen to the sound that is transmitted from the
buttons	connected QLR1660 Client.
	- Control the volume by moving the volume control button.
	[NOTE] For full-duplex audio communication with the QLR1660 Client system,
	the amplified microphone has to be connected to QLR1660 card and
	an audio that microphone is connected actually has to be enabled at ‘Audio
	recording and transferring' in System setup panel.

*Calling Message Window

:If the QLR1660 client tries to audio-communicate using ‘Call’ button (), the ‘Calling message’ window is displayed as below.

If you click ‘OK’, the below window is displayed.

22