HoMedics HJM-PED1 Cleaning and Care, Troubleshooting, Problem Possible Cause Solution

Installing Instructions
1. Remove demineralization cartridge from packaging and
let it soak in water for 10 minutes.
2. Remove the tank from humidifier base. (Fig. 3)
3. Place 1 demineralization cartridge down into left	Fig. 8
side matching slot in the humidifier base. (Fig 9)
4. Place the tank back on the base, making sure the tank is

firmly seated. (Fig. 7)

Cleaning and Care
CAUTION: Before cleaning the unit, turn power off and	Fig. 9
unplug unit from the outlet.

Troubleshooting

PROBLEM	POSSIBLE CAUSE	SOLUTION
Power Light is off	• Unit is not plugged in	• Plug unit in
		• Press the POWER button
		to turn the power on
	• No power at unit	• Check circuits, fuses, try a
		different outlet
SoundSpa will not	• Unit is not plugged in	• Plug unit in
turn on	• Volume is down too low	• Turn the SOUNDSPA
		POWER/VOLUME knob
		clockwise to increase
		volume
	• No sound selection has	• Press a sound selection
	been made	button to choose a sound

Fig.10

Fig.11

Tank Cleaning

Remove the water tank from the humidifier base by lifting it by the handle from the main unit. Unscrew the tank cap; wipe the tank with a soft cloth then rinse it with clean water. (Fig. 10)

Suggestion: Clean the water tank once every two to three weeks, depending on your water conditions.

Ultrasonic Nebulizer Cleaning

Put small amount of mild dish soap on the surface of the ultrasonic nebulizer, then pour in some water and soak for 5 minutes. Brush clean with soft bristle brush (not included) and rinse. (Fig. 11)

Surface Cleaning

Clean the surface of the unit with a clean damp soft cloth. (Fig. 12)

	• Sleep Mode cycle is over	• Use the SOUNDSPA
		POWER/VOLUME knob to
		turn the SoundSpa OFF,
		then back ON again.
Peculiar Odor	• If new unit	• Open the water tank cap
		and keep it in a shady and
		cool place for 12 hours
	• If unit is in use, the odor	• Empty the old water,
	may be a dirty tank or old	clean the tank and fill
	tank water	with clean water
Excessive Noise	• Unit is not level	• Place unit on a flat,
		even surface
	• Low water level	• Check the water level. Refill
		the tank if the water is low
White Dust Accumulation	• Hard water used	• Use distilled water and a
		Demineralization Cartridge
	• Demineralization Cartridge	• Replace Demineralization
	needs replacement	Cartridge

Fig.12

10

11