Hunter Fan 43553-01 installation manual Threaded rod from the upper light housing

1 • Installing the Light fixture on Fans With Removable Switch Housings

1.Unscrew the three screws from the upper switch housing. Disconnect the 9-pin plug connectors. Remove the lower switch housing.

2.Push the plug button from inside the lower switch housing to remove the plug button and switch housing cap.

NOTE: Save the plug button and switch housing cap should you choose to remove the light fixture in the future.

3.Feed the two wires from the light fixture through the center hole in the lower switch housing.

4.	Screw the threaded rod of the light fixture into the center of the lower		Removable Switch Housing
	switch housing until you feel resistance. Unscrew the light fixture
	slightly until the holes of the light fixture are aligned with the holes in
	the lower switch housing.
5.	Finish attaching the light fixture to the lower switch housing using the			9-Pin Plug
	two attachment screws included. Securely tighten the two screws.
6. Install the nut and washer inside the lower switch housing onto the				Connector
	threaded rod from the upper light housing.
		Nut	Screw
		Washer
				Lower Switch
		Lower		Housing
	Threaded		Steps 1-2	Plug Button
		Switch
	Rod
		Housing

WARNING: Improper installation could cause the light fixture to fall, or result in electrical shock or personal injury.

	Attachment
Light	Screws
Fixture	Steps 3-6

4

43553-01 • 05/15/09 • Hunter Fan Company