3 • Installing the Light fixture on the Hunter Originals
1.Uninstall the two screws from the switch housing plate.
NOTE: Save the switch housing plate should you choose to remove the light fixture in the future.
2.Remove the wire connectors from the two wires in the switch housing labeled “Connect Light Here” or “For Light Use.” One wire is white and the other wire is black wire with a white stripe. Thread the two wires through the hole in the center of the light fixture.
3.To connect the wires, hold the bare metal leads together and place a wire connector over them, then twist the wire connector clockwise until tight.
Connect the black/white striped wire from the switch housing to the black wire from the light fixture. Connect the white wire from the switch housing to the white wire from the light fixture. Secure all wire connections using wire connectors.
CAUTION: Be sure no bare metal wires or wire strands are visible after making the connections.
4.Attach the light fixture to the switch housing with the two screws, included with the light fixture, aligning the holes in the fixture, switch housing cover, and switch housing.
5.Securely tighten the two screws.
6.Go to the instructions for Installing the Bulbs and Shades.
Screw
Switch
Housing
Plate
WARNING: Improper installation could cause the light fixture to fall, or result in electrical shock or personal injury.
Light
Fixture
Wires
and Wire
connectors
Steps
8