4.Remove the bracket-HDD (A) from the product by disconnecting the power supply cable, signal transmission cable (IDE cable), and fan cable then pulling it toward the center of the product to disconnect its fixed part from the bottom. Remove the bracket-HDD (B) by lifting it up after removing the screws.
5.Mount the HDD to the bracket-HDD with the (A)SCREW-SPECIAL (BWH,6-32UNC,L10.5) and (B)SCREW-TAPTITE (BH,+,S,M3,L6,ZPC) (4 spots) that was provided as an accessory. (The screws have to be tightened so that it doesn’t vibrate loose.)
English 2-14
