Polycom Guide to Installing C12 and C8 Stereo Systems

Installing The SoundStructure C16, C12, C8, And SR12

Rear Panel

The rear-panel of the Polycom SoundStructure C16 is shown in the following figure.

								PIN 2: TXD		1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16	OUTPUTS
								PIN 3: RXD
								PIN 5: GROUND
								PIN 7: CTS
								PIN 8: RTS
								RS-232	REMOTE CONTROL 1
										1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16	INPUTS
		LAN	C-LINK2	IN	OBAM	OUT	IR 12V		REMOTE CONTROL 2															SoundStructureTM C16
			5				7
1	2	3	4		6		8	9	10	11	12			13

1	AC power connection	8	IR receiver interface
2	Expansion slot for SoundStructure	9	RS-232 interface
	plug-in cards
3	Ethernet interface	10	Logic input and output connector
4	Conference Link2 (CLink2)	11	Logic input and output connector 2
	interface
5	OBAM input status LED	12	Balanced audio input connectors
6	OBAM input and output ports	13	Balanced audio output connectors
7	OBAM output status LED

Installing The Hardware

To install a SoundStructure device, follow these steps:

•Install optional plug-in card. (See page 2-4.)

•Mount the SoundStructure device onto an equipment rack or other location. (See page 2-6.)

•Connect to LAN for control management. (See page 2-7.)

•Use Conference Link2 to connect to Polycom HDX system. (See page 2-7.)

•Use OBAM to connect multiple SoundStructure devices. (See page 2-9.)

•Connect IR port to optional receiver and/or RS-232 to control system. (See page 2-12.)

•Connect other devices/equipment using analog input/output. (See page 2-14.)

•Connect optional logic devices. (See page 2-15.)

2 - 3