Polycom C8, SR12, C12, C16 manual Data Equipment, Canada

Page 51

Regulatory Notices And Warranty Information

Data Equipment

The table below shows which jacks are associated with which modes of operation:

Mode of Operation

USOC Jack

 

 

Permissive

RJ11C

 

 

Automatic Dialing

WHEN PROGRAMMING EMERGENCY NUMBERS AND/OR MAKING

TEST CALLS TO EMERGENCY NUMBERS;

Remain on the line and briefly explain to the dispatcher the reason for the call.

Perform such activities in the off-peak hours, such as early morning or late evening.

Canada

Canadian EMC Class A

English Statement:

This Class [A] digital apparatus complies with Canadian ICES-003.

French Statement:

Cet appareil numérique de la classe [A] est conforme à la norme NMB-003 du Canada.

This product meets the applicable Industry Canada technical specifications.

The Ringer Equivalence Number (REN) assigned to each relevant terminal device provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5.

The REN of this equipment is either marked on the unit or included in the new style USA (FCC registration number). In the case that the REN is included in the FCC number the user should use the flowing key to determine the value:

The FCC number is formatted as US: AAAEQ##TXXX.

##is the Ringer Equivalence Number without a decimal point (e.g. REN of 1.0 = 10, REN of 0.3 = 03). In the case of a “Z” ringer, ZZ shall appear. In the case of approved equipment without a network interface and equipment not connecting to circuits with analog ringing supplied then “NA” shall appear.

6 - 3

Image 51
Contents Revision a Trademark Information Contents Logic Examples Accessories -1 Regulatory Notices And Warranty InformationOverview Preparing For InstallationProduct Features Installation OverviewPackage Contents Page Safety Recommendations Tools Needed For InstallationGeneral Site Requirements Power Supply ConsiderationsPanel Diagrams Installing The SoundStructure C16, C12, C8, And SR12Front-panel LEDs are interpreted as follows Front-PanelRear Panel Installing The HardwarePlug-in Card Installation Phone Line Rack-Mounting The Polycom SoundStructure Device Connecting To Other Polycom Equipment With Conference Link2 Connecting To The LAN InterfaceLINK2 Obam OUT Device ID’s SoundStructureTM C8 IR Port RS-232 Making Audio Connections Balanced Audio Connections Unbalanced Audio Connections Connecting Logic PortsRemote Control Pin Signal Logic Inputs Logic Outputs Logic Output High On Low Off Powering Up The SystemConfiguring The SoundStructure Devices Technical Specifications SpecificationsThermal Telco Conference Link2 Pin Out SummaryWhite Obam LinkRS-232 IR ReceiverLogic Interface Audio Connections Balanced Audio Connections Unbalanced Audio Connections Page Contact Closure Logic InputSoundStructure Powered Relay Externally Powered RelayLogic Output Driving An LED Push To Talk Microphones Logic Input And OutputAnalog Gain Control Page Accessories Page USA And Canada Regulatory NoticesExhibit J Customer Information Canada Data EquipmentČesky Czech EEA European Economic Area Including SwitzerlandΕλληνική Greek Polish Center for Testing and Certification Notice Dyrektywy 1999/5/WE Japan Vcci AustraliaRest Of World KoreaWarranty Information Regulatory Notices And Warranty Information