Polycom C12, SR12, C16, C8 manual Connecting To The LAN Interface

Page 17

Installing The SoundStructure C16, C12, C8, And SR12

Connecting To The LAN Interface

The SoundStructure device's Ethernet interface (as shown following figure) is

a10/100 Mbps interface that supports Auto-MDIX (medium dependent interface crossover).

Auto-MDIX enables the use of a standard CAT5e cable to connect directly from the SoundStructure device to either an Ethernet network or to a computer. The SoundStructure device will detect the connection and work appropriately.

PIN 2: TXD

PIN 3: RXD

PIN 5: GROUND

PIN 7: CTS

PIN 8: RTS

RS-232

1

2

REMOTE CONTROL 1

1 2

LAN

C-LINK2

IN OBAM OUT

IR 12V

REMOTE CONTROL 2

LAN

By default the SoundStructure device has Dynamic Host Configuration Protocol (DHCP) enabled and will accept an IP address from a DHCP server. The SoundStructure device IP address can also be set to a static IP address using the SoundStructure Studio software.

Do not plug the Ethernet cable in to the Conference Link2 ports. To minimize improper cabling, plastic plugs have been installed by default into the Conference Link2 ports.

Warning Connecting an Ethernet cable into the Conference Link2 interface of a

SoundStructure device could damage the SoundStructure device.

Connecting To Other Polycom Equipment With Conference Link2

The Conference Link2 interface (shown in the following drawing and labeled C-Link2) is used to connect the SoundStructure devices to other Polycom equipment such as a Polycom HDX system. There are two Conference Link2 interfaces on each SoundStructure device to support future connectivity to more than one Polycom device. The Conference Link2 ports on the SoundStructure devices have a plastic plug that must be removed before inserting a cable into the Conference Link2 ports. The Conference Link2 ports

2 - 7

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Revision a Trademark Information Contents Logic Examples Accessories -1 Regulatory Notices And Warranty InformationOverview Preparing For InstallationProduct Features Installation OverviewPackage Contents Page Safety Recommendations Tools Needed For InstallationGeneral Site Requirements Power Supply ConsiderationsPanel Diagrams Installing The SoundStructure C16, C12, C8, And SR12Front-panel LEDs are interpreted as follows Front-PanelRear Panel Installing The HardwarePlug-in Card Installation Phone Line Rack-Mounting The Polycom SoundStructure Device Connecting To Other Polycom Equipment With Conference Link2 Connecting To The LAN InterfaceLINK2 Obam OUT Device ID’s SoundStructureTM C8 IR Port RS-232 Making Audio Connections Balanced Audio Connections Unbalanced Audio Connections Connecting Logic PortsRemote Control Pin Signal Logic Inputs Logic Outputs Logic Output High On Low Off Powering Up The SystemConfiguring The SoundStructure Devices Technical Specifications SpecificationsThermal Telco Conference Link2 Pin Out SummaryWhite Obam LinkRS-232 IR ReceiverLogic Interface Audio Connections Balanced Audio Connections Unbalanced Audio Connections Page Contact Closure Logic InputLogic Output SoundStructure Powered RelayExternally Powered Relay Driving An LED Push To Talk Microphones Logic Input And OutputAnalog Gain Control Page Accessories Page USA And Canada Regulatory NoticesExhibit J Customer Information Canada Data EquipmentČesky Czech EEA European Economic Area Including SwitzerlandΕλληνική Greek Polish Center for Testing and Certification Notice Dyrektywy 1999/5/WE Japan Vcci AustraliaRest Of World KoreaWarranty Information Regulatory Notices And Warranty Information
Top Page Image Contents