Samsung DVD-CM500H/XEF manual Connecting DVD-VCR to the TV using the Coaxial Cable

Page 11

Connecting DVD-VCR to the TV using the Coaxial Cable

To receive television programmes a signal must be received from one of the following sources:

◆An outdoor aerial

◆An indoor aerial

◆A cable television network

◆A satellite receiver

☛Make sure that both the television and the DVD-VCR are switched off before connecting the cables.

1Remove the aerial or network input cable from the television.

2Connect this cable to the 75Ω coaxial socket marked on the rear of your DVD-VCR.

3	Plug the coaxial cable supplied into the TV socket on your
	DVD-VCR.

4Plug the other end of the coaxial cable into the connector previously used for the aerial on the television.

5To obtain better pictures and sound quality on your television, you can also connect your DVD-VCR to the television via the SCART cable (see section below) if your television is equipped with this type of connection.

DVD & VCR	AUX
	AUDIO
	IN	OUT
RADIO ANT.	R
RADIO ANT.
	L	GB
2
	VIDEO

TV	DVD & VCR	AUX
TV		AUX
		AUDIO
	IN	OUT
	RADIO ANT.	R
	RADIO ANT.
	FM
	75	L
	COAXIAL
	AM
	4	VIDEO
	4
	3

Connecting DVD-VCR to the TV using the SCART Cable

Aerial
TV
DVD & VCR	AUX
	AUX
	AUDIO
IN	OUT
RADIO ANT.	R
RADIO ANT.
FM
75	L
COAXIAL	2
	2
AM
3	VIDEO
3
SCART Cable
RF coaxial cable

You can connect your DVD-VCR to the television using the SCART cable if the appropriate input is available on the television. You thus:

◆Obtain better quality sound and pictures

◆Simplify the setting up procedure of your DVD-VCR

☛◆ Regardless of the type of connection chosen, you must always connect the coaxial cable supplied. Otherwise, no picture will be visible on the screen when the DVD-VCR is switched off.

◆Make sure that both the television and the DVD-VCR are switched off before connecting the cables.

1Connect the coaxial cable as indicated in the above section.

2Connect one end of the SCART cable to the AV1 (EURO AV) socket on the rear of the DVD-VCR.

3Plug the other end into the appropriate connector on the television.

11

Image 11

Contents DVD-CM500 GB Contents Playing Back Symbols Following illustrations represent precautions Safety InstructionsPlayback Region Number Disc Type and CharacteristicsDisc Markings Rear View of the DVD-VCR Front View of the DVD-VCR33 UP 34 OK Infrared Remote ControlShuttle PROG/TRKCopy mode indicator Display IndicatorsAccessories Recommended Use Deciding How to Connect DVD-VCRYour DVD-VCR is equipped with the following connectors Connector Location TypeConnecting DVD-VCR to the TV using the Scart Cable Connecting DVD-VCR to the TV using the Coaxial CableAV2 in By means of 21-pin Scart Cable AV1EURO AV By means of 21-pin Scart CableBy means of RF Coaxial Cable Plug & Auto Set up Tuning Your Television for the DVD-VCR VCR Button Deck Control KeysSTANDBY/ON Button DVD ButtonBasic TV Tuner Operations Inserting Batteries in the Remote ControlFind that the remote control is no longer working correctly Copy the DVD to VHS Tape Copying from DVD to VCRInsert VHS Tape Insert a blank VHS videotape into the VCR deckSelect Language Setting the Date and TimeSetting the Menu Language Open MenuVCR Presetting the Stations AutomaticallyPicture, if necessary Presetting the Stations Manually13 To...Then If you ThenResult The TV Station Table menu is displayed Clearing a Preset StationPress the OK or ❿ to select a Manual Setup option Press the corresponding Or ❷ buttons, until the ManualTelevision screen Changing the Preset Station TableSetting the DVD-VCR Output Channel Selecting the RF OUT Sound Mode B/G-D/KConditions Selecting the Colour ModeOK or ❿, until Distorted due to inferior receptionIntelligent Picture Control Off 1Hour 2Hour 3Hour Auto Power OffShowView Extend Press the corresponding or ❷ buttons, untilE180 E240 300 E260 Screen MessagesSelecting the Cassette Type Press OK or ❿, untilDVD-VCR allows you to playback high quality S-VHS tapes Repeat PlayVHS Play Selecting the Recording Speed VCR Recording a Programme Immediately VCR Protecting a Recorded CassetteRecording a Programme with Automatic Stop If you wish to cancel the recording before the end, pressPressing VCR Using the ShowViewSelect the recording speed Modifying ShowView ProgrammingIf you wish to Then Press the OK or ❿ button to select Standard option Using the Timer Programming FeaturePreset Insert the cassette and press Timer on the remote controlCancelling a Preset Recording Checking a Preset RecordingThen press Adjusting Picture Alignment ManuallyPlaying a Cassette You can play a cassette in slow motion Selecting the Audio Output ModePlaying a Cassette in Slow Motion Option DescriptionPlaying a Sequence at Variable Speeds Seq Searching for a Specific SequencePrev NextButtons, until the Intro Scan option is selected Intro ScanUsing the Tape Counter VCR Connecting an RCA Audio/Video Input Cable Recoding from Another VCR or Camcorder CD, DVD Audio Dubbing a Pre-recorded CassetteButton Function Using the TV Buttons on the Remote ControlBrand Codes Jack Choosing a ConnectionConnection to an Television Using the Disc Menu Language Setting Up the Language FeaturesPress the ,❷ buttons to select ‘English’ Using the Audio LanguageUsing the Subtitle Language Setting Up the Audio Options About the Rating Level Setting Up the Parental ControlAbout the Change Password ❿ buttonConnect S-Video Out to TV Setting Up the Display OptionsSends Component Interlace signal from Video Connections for DVDTo Component Input on Your TV DVD Component Connections for DVDSpecial Playback Features For 43 aspect ratio discs Adjusting the Aspect Ratio EZ ViewTo play back using aspect ratio DVD If you are using a 169 TV For 169 aspect ratio discsPan Scan If you are using a 43 TVDisplays the content of the DVD title in 43 aspect ratio For 169 aspect ratio discs Letter BoxWhen Playing a DVD Using the Display Function DVD/VCD/CDSelecting the Subtitle Language Using the Angle buttonUsing the Subtitle button Changing the Camera AngleDVD Repeat Play Using the Zoom DVD/VCDSelecting the Audio Language Repeat Chapter/TitleClearing a Mark DVD Using the Mark Function DVD/VCDUsing the Mark Function DVD Recalling a Marked SceneSelect the track, and then press the OK button. Playback MP3-CD PlaybackList of albums in the folder will appear To view the next album, press the Return buttonWMA Disc Playback WMA PlayDo not try recording copyright protected MP3 files MP3/WMA PlayYour MP3 or WMA files should be ISO 9660 or Joliet format Then press the OK button Program Play & Random PlayThumbnail screen Picture CD PlaybackCD-R Jpeg Discs Distance of a m Setting ms Distance of B m Setting the Delay TimeSetting the Center Speaker Setting the Surround SpeakersFront Speakers About Speaker SetupCenter Speaker Surround SpeakersTo Set the Bass/Treble To Set the Speaker BalanceTo Test the Speakers Dolby Pro Logic Sound Mode FunctionSound Mode Tune in to the desired station Automatic TuningPress and hold l or ❿❿l to begin automatic tuning Listening to the RadioPresetting Stations Output Technical SpecificationsInput Check the TV/VCR aerial connections Problems and Solutions VCRProblem Action Troubleshooting Guide DVDBefore requesting service troubleshooting Ellas Greece Fourlis Trade A.E.B.E Electronics

Related manuals

Manual 41 pages 44.57 Kb

Manual 2 pages 20.88 Kb