Samsung WF70F5E0W4W/EF, WF80F5E0W4W/LE manual Excessive suds, Detergent, Stops, Temperature

PROBLEM	ACTION
	•	Press or tap Start/Pause to stop the washing machine.
	•	It may take a few moments for the door lock mechanism to disengage.
	•	The door will not open until 3 minutes after the washing machine has
		stopped or the power turned off.
The door does not open.	•	Make sure all the water in the drum is drained.
	•	The door may not open if water remains in the drum. Drain the drum and
		open the door manually.
	•	Make sure the door lock light is off. The door lock light turns off after the
		washing machine has drained.
	•	Make sure you use the recommended types of detergent as appropriate.
	•	Use high efficiency (HE) detergent to prevent oversudsing.
Excessive suds.	•	Reduce the detergent amount for soft water, small loads, or lightly soiled
		loads.
	•	Non-HE detergent is not recommended.
Cannot apply additional	•	Make sure the remaining amount of detergent and fabric softener is not
detergent.		over the limit.
	•	Plug the power cord into a live electrical outlet.
	•	Check the fuse or reset the circuit breaker.
	•	Close the door and press the Start/Pause button to start the washing
		machine. For your safety, the washing machine will not tumble or spin
		unless the door is closed.
	•	Before the washing machine starts to fill, it will make a series of clicking
Stops.		noises to check the door lock and does a quick drain.
	•	There may be a pause or soak period in the cycle. Wait briefly and the
		washing machine may start.
	•	Make sure the mesh filter of the water supply hose at the water taps are
		not clogged. Periodically clean the mesh filter.
	•	If the washing machine is not supplied with sufficient power, the washing
		machine temporarily will not drain or spin. As soon as the washing
		machine regains sufficient power, it will operate normally.
	•	Fully open both taps.
	•	Make sure the temperature selection is correct.
	•	Make sure the hoses are connected to the correct taps. Flush water lines.
	•	Make sure the water heater is set to supply a minimum 120 ˚F (49 ˚C) hot
		water at the tap. Also, check the water heater capacity and recovery rate.
Fills with the wrong water	•	Disconnect the hoses and clean the mesh filter. The mesh filter may be
		clogged.
temperature.	•	While the washing machine fills, the water temperature may change
		as the automatic temperature control feature checks incoming water
		temperature. This is normal.
	•	While the washing machine fills, you may notice just hot and/or just cold
		water going through the dispenser when cold or warm temperatures are
		selected. This is a normal function of the automatic temperature control
		feature as the washing machine determines the water temperature.

English - 36

Untitled-36 36

2017-03-22 ￿￿ 8:11:59