Samsung SCC-520P Installation, Specifications, Check what is inside the package, Cable connection

Installation

■Check what is inside the package

•Check to see if the following parts are included in the purchased package.

Camera tab screw User's guide

■Notes on installation and usage

1.Users should not disassemble the camera from the front direction.

2.Always handle the camera with care. Please do not apply a shock or vibration as much as possible and take cautions not to cause damage or make a scratch on the camera due to careless storage.

3.Please do not install the camera with the rainy place or highly humid areas. And do not operate the camera in the wet place.

4.Do not clean the camera body with the strong abrasives or soaps. When the camera becomes dirty, clean it with the dry rugs. Especially, make sure to use the dedicated rugs for lens to clean the dome cover.

5.Please select the camera in the cool area that is not exposed to the direct sunlight. If you do, it can cause bad effects on the product.

4 Attach the camera on the target location with the screw driver using the provided tab screw.

Wall or ceiling

Main body

Screw Driver Tab screw

5 Set the proper image by moving the camera body (PCB board) inside the dome camera upward or downward and set the focus by turning the lens to the left or right direction.

Wall or ceiling

Adjust the	Adjust focus by
image upward
	turning left or right
or downward

6 Assemble the dome cover by turning it clockwise.

Note Please make sure that any foreign matter gathers on the lens cover when assembling or disassembling the dome cover.

■Cable connection

1Hold the camera body with one hand and turn the dome cover counterclockwise with other hand in order to disassemble it.

2 Connect the BNC cable to the video cable connector attached on the dome camera, and connect the remained BNC cable to the video input terminal of the monitor.

3 Connect the power adaptor at this time. Connect the DC 12V power cable of the connector to the power cable connection that is attached on the dome camera. For connection of the AC input of the adaptor, please select 110V or 220V switch in advance.

Monitor

BNC Cable 220 110

Power Cable ( )

Specifications

Item	Details
Broadcasting method	SCC-520N:NTSC STANDARD
	SCC-520P :PAL STANDARD
CCD	1/3" SUPER HAD IT CCD
Valid pixel	SCC-520N: 510(H) x 492(V)
	SCC-520P : 500(H) x 582(V)
Synchronization method	Internal
Resolution	H : 330 TV Lines, V : 350 TV Lines
Signal output	VBS 1.0Vp-p(75Ωcomposite)
S/N rate	48dB
Lowest illumination	2Lux(F2.0, 50 IRE)
of the thing pictured
Gamma correction	0.45
In/out connector	Signal output: BNC, Power input : DC jack
Operational temperature	-10~+50°C
Voltage	DC 12V, 200mA
Power consumption	2 W
Lens	Focal Length(f) : 3.8mm
	Aperture Ratio(F) : 2.0
External size	UP/Version DATA
	100(ø) x 67(H)mm
Weight	150g