Lightolier IS:LLACSW installation instructions Optical Assembly Adjustment, For wall mount

	IS:LLACSW
Page 1 of 2	10-08/Rev-01

Installation Instructions for Surface LED

Colorwash Luminaire

CAUTION: Please read these instructions before installing the luminaire. To avoid electric shock, turn off the power from the electric panel before beginning. For safety, this luminaire must be grounded. Consult an electrician to make sure all the requirements of the US or Canadian Code for electricity and the current local regulations comply. Keep these instructions as reference.

Note 1: This portable luminaire (Fig.1) uses LED (light emitting diode lamps), which require no maintenance. Designed for residential, commercial and industrial applications, non hazardous dry locations, ceiling (Fig.2), wall-mounted (Fig.3) and floor applications (Fig.4).

Note 2 : This portable luminaire includes a 96 in. extension cord and can also be hardwired using flexible metal conduit (Fig.5), two 3/8 in. connectors are supplied.

Portatif ColorWash Ceiling Wall Floor Daisy Chain

FIG.1 FIG.2 FIG.3a

A. OPTICAL ASSEMBLY ADJUSTMENT:

1.Adjust head on assembly at the desired angle. (Fig.6)

2.Lock in place inserting locking screws through hinge. (Fig.7) Note: Use a 3/16 in. Allen key (not supplied).

B.CEILING or WALL MOUNT INSTALLATION: (Fig.2)

Note: Provide anchors to support 8 lb (3.6kg) luminaire.

For ceiling mount

1.Install 2 anchors at 20-1/2 in. (520mm) from luminaire center. (Fig.8)

Note: For more stability, install 4 anchors 2 in. from center of the luminaire. (Fig.9)

For wall mount

1.Mount 2 anchors 15 in. (381mm) apart. (Fig.12)

2.Determine light beam orientation (uplight or downlight). (Fig.3a & 3b)

3.Loosen screw from the mounting tabs. (Fig.10 & 11)

4.Rotate and position oblong holes located at each end. (Fig.11)

5.Locate embossed holes and screw in place. (Fig.10 & 11)

6.Install screws (not provided) through oblong holes. (Fig.8 & 9)

D. FLOOR INSTALLATION:

1.Position mounting tabs towards front of the luminaire (for stable floor standing), or at each end. (Fig.10 & 11)

2.Loosen screw from the mounting tabs. (Fig.10 & 11)

3.For more stability depending on optical assembly orientation, secure with 2 screws from each end of assembly (optional). (Fig. 9 & 12)

4.Locate embossed holes and screw in place. (Fig.10 & 11)

5.Install screws through oblong holes. (Fig.12)

FIG.3b		FIG.4		FIG.5
LOCKING	HINGE		HEAD ON
SCREW

FIG.6

FIG.7

ALLAN KEY

ANCHOR

LUMINAIRE

FIG.8

LUMINAIRE

	EMBOSSED				HOLE
				SCREW
			MOUNTING
FIG.9			TAB
				FIG.10
		SCREW

MOUNTING TAB FIG.11

Lightolier is a Philips group brand