Samsung AR09JSFPEWQNZE, AR12JSFPEWQNET manual Drain hose installation, English-39, Be bent

Installing and connecting the drain hose of the indoor unit

When installing the drain hose for the indoor unit, check if condensation draining is adequate. When passing the drain hose through the 65 mm hole drilled in the wall, check the followings:

Wall

Indoor unit

Drain hose

The drain hose must NOT	The end of the drain hose must NOT
slant upwards.	be placed under water.

	5cm	Ditch
	less
The drain hose must not	Keep a clearance of at least	Do not place the end of the
be bent.	5cm between the end of the	drain hose in a hollow.
	drain hose and the ground.
1) Correct connection	2) Incorrect connection

Drain hose Pipe Drain hose Pipe

• Don’t tie drain hose to the assembly pipe which may lead to water leakage.

Drain hose installation

1.If necessary, connect the 2 meter extension drain hose to the drain hose.

2.If you use the extension drain hose, insulate the inside of the extension drain hose with a shield.

3.Fit the drain hose into 1 of 2 drain hose holes, then fix the end of the drain hose tightly with a clamp.

• If you do not use the other drain hose hole, block it with a rubber stopper.

4. When extending the Drain Hose, hold the end of Drain Hose and Extended Hose,	Drain hose hole
rotate and insert the drain hose into Extended hose for 40~45 mm. Make sure the
two hoses are firmly connected, there is no water leakage.

5.Connect the Drain Hose after using Foam Insulation to wrap the Extended Hose. Then, Use vinyl tape to wrap the each side of connection by 20 mm .

English-39

t05s In llan atio

Maldives ET IB&IM_DB68-06219A-00_EN.indd 39

2016/5/16 10:26:50