HOW TO ADJUST THE DOORS HEIGHT
When any one of the doors is lower
than the other,
• Check if the Refrigerator is leveled before adjusting the door.
• The door height difference can be adjusted by inserting the Snap Ring ( 1 ). (It only applies to the
right door for the Refrigerator Doors.)
1
•After checking the height difference, select a Snap Ring with suitable thickness. When inserting the Snap Rings two or more. it may cause the Snap Rings slipping out or rubbing noise. So, make sure to insert only one.
•Lift up the lower lying door and insert the Snap Ring into the space between the Door and the Hinge.
•When inserting or removing the Snap CAUTION Ring, take care not to get injured.
•Keep the Snap Rings out of the reach of the children and make sure that the children does not play with them or put them into their mouth.
•1 mm, 1.5 mm, 2 mm, and 2.5 mm Snap Rings come with the Refrigerator.
•When the Refrigerator is leveled before loading the food, the Refrigerator may get unleveled due to its weight. In this case, adjust it again with the same procedure.
•When the door gets raised too much, it may cause friction between the door and the Top Cover
Check the accessory list below.
1 mm | 1.5 mm | 2 mm | 2.5 mm |
|
|
|
|
18_ setting up
HOW TO ADJUST THE DOORS GAP
If the gap between the left and right fridge compartment doors is not even.
• You can adjust the gap by turning the bolt at the top right of the cold storage compartment door.
•If the bold is turned excessively, the bolt may break.
1.When the doors are closed, remove the 3 screws fixing the top cover using a Phillips screwdriver before lifting it up together with the connected cables.
2. Turn the bolt with a 4 mm hexagonal
3. Turning the bolt clockwise
( | ) widens the gap while turning the bolt | |
counter clockwise ( | ) narrows the gap. |
Adjust the gap between the doors like this.
2016. 6. 25. |
�� 8:51