Samsung RF905QBLASL/ZA Disassemble the Freezer Doors, Screwdriver and disassemble the Connector

DISASSEMBLE THE FREEZER DOORS

•Be sure to remove the Fridge Door CAUTION before removing the Freezer Door.

•Be cautious with the wires being attached on the bottom of the Freezer Door while doing the disassembling.

1.With the Door being open, remove the screw holding the cover (A) of the Adjust Leg at the bottom of the Door with the Phillips (+)

Screwdriver and disassemble the Connector

(B).

A

B

REATTACHING THE

REFRIGERATOR DOORS

•Be sure to assemble the Freezer Door CAUTION before assembling the Fridge Door.

•Before doing the assembling, make sure that all the wire connectors at the bottom of the Freezer Door are assembled.

How to Assemble Freezer Door

1.Insert the door into the lower hinge (A) in the direction of (1) and then push the door in the direction of (2). At this time, take care not scratch the door with the Mid-Hinge (B).

2.Lift up the Mid Hinge Cap(C) on the Door Hinge above the Freezer Door to remove.

C

3.While pushing the Door in the direction of the arrow, lift up the Mid Hinge Shaft (D).

B

2

A1

•Be careful with the wires on the bottom CAUTION of the door not being damaged by being

stomped on, etc.

2.Insert the Hinge Shaft (C) into the Mid Hinge Hole (D) and put on the Hinge Cap (E).

When assembling the Hinge Shaft and the Hinge Cap, be sure to check its assembling direction.

D

4.Be careful that the Door does not touch on the Mid Hinge (E). And, tilt the Door forward a little and lift it up to remove.

1

E 2

16_ setting up

C	E
	D

3.With the Door being open, assemble the connector on the bottom of the Door.

DA68-02836A-06.indb 16 2016. 6. 25.

�� 8:51