¦¦ Setting Up Your Remote
You can set up your 3” LCD Touch Control to control your TV in three ways:
As a standard, IR (Infra Red) remote
As an IR remote, your LCD Touch Control works the same way as a standard push button remote, except you touch icons and symbols on the LCD screen to control your TV instead of pushing buttons. Using your Touch Control as an IR remote requires no more set up than a standard remote and gives you access to most of the remote’s functions and features.
As an extended distance, Wi-Fi remote
As an extended distance,
or content that is on your TV screen on the LCD screen of the Touch Control. The long distance,
As a networked, Wi-Fi remote
As a networked,
The networked,
¦¦ Setting up the Network
01 Getting Started
You can set up a wireless network for the
How to connect using PBC (WPS)
If your router has a PBC (WPS) button, follow these steps:
1.Connect your TV to your LAN.
2.On the Services screen, touch Settings → Remote Settings.
3.Touch Network.
4.Touch the PBC(WPS).
Press the PBC button on the
access point within 120
seconds.
Remaining Time : 112
Stop
5.If the Press PBC button on the access point within 120 seconds. message appears,
press the PBC button on the device to connect.
✎✎ For more information, refer to the wireless network setup manual of the device to be connected.
6.If the device is connected properly to the TV after starting count on message box then message box will be disappeared
automatically.
✎✎ If the connection fails, please retry after 2 minutes.
Connecting to network
To setup the wireless connection automatically, follow these steps:
1.Follow Steps 1 through 3 in the “How to connect using PBC (WPS)” procedure. ✎✎ If the intended network cannot be found in the list, select to open the list of
networks again.
2.Select a network and connect to the network using the encryption method (PIN, security key,
3.When the network connection is complete, select Test to perform a network test.
✎✎ For the automatic IP, the AP will automatically define the IP Address, Subnet Mask, Gateway and DNS server.
✎✎ For the manual IP, you can select Edit and directly enter the IP Address, Subnet Mask, Gateway and DNS server.
✎✎For Full Touch Control instructions, please read the Touch Control’s user manual.
Network
Select a network.
Auto Configuration
Unsecured
Secured
Unsecured
Secured
PBC(WPS)