Connecting network with WPS setting
[ Remote control TYPE 1]
1
[ Remote control TYPE 2]
2
01 Preparation
1.[ Remote control TYPE 1] After pressing and holding the [Setting] button on the remote control for 4 seconds. [Remote control TYPE 2] After pressing the [2ndF] button on the remote controller, press the [WPS] button.
2.Press [WPS] button on the wireless router that will be connected to an air conditioner and operate the WPS function of the wireless router. (The location of WPS button may be different depending on the wireless manufacturing company.)
3.After connecting the air conditioner with the wireless router correctly, the
• Check whether the wireless router supports
NOTE • Check whether the wireless router has WPS button.
•Samsung smart air conditioner uses PBC method of WPS.
•When searching a network by pressing [WPS] button, the remote controller will not work for a maximum of 2 minutes.
•Be careful when pressing the WPS button because if you hold the WPS button for a long time, the set value of the wireless router will be initialized with some types of wireless router.
•Operating wireless router through WPS mode might be different depending on the manufacturing company.
Therefore, please refer to the user manual of your wireless router.
•If the wireless router(AP) is not authenticated with WPS, connection failure might occur.
CAUTION | • Some of the wireless routers (including wireless routers that are not authenticated with WPS) may lose connection |
| with previously connected devices when the air conditioner establishes connection with wireless router. |
English-11
4/25/2014 10:06:33 AM