Samsung AR24JRFSBWKNMG, AR24JRFNBWKNMG manual Adding Refrigerant, English-49, Outer Torque

Page 49

Evacuating the connected pipes

1.Connect each assembly pipe to the appropriate valve on the outdoor unit and tighten the flare nut.

2. Tighten the flare nut first with your hands, and then with a torque wrench, applying the following torque.

• Excessive torque can be cause of gas leakage.

3.Connect the charging hose of the low-pressure side of manifold gauge to a gas service port as seen in the picture.

4.Open the valve of the low pressure side of manifold gauge counterclockwise.

5.Evacuate the air in the connected pipes using the vacuum pump for about 15 minutes.

Make sure that pressure gauge shows -0.1 MPa(-76 cmHg) after about 10 minutes.

This procedure is very important to avoid a gas leak.

Close the valve of the low pressure side of manifold gauge clockwise.

Turn off the vacuum pump.

Check for 2 minutes if there is any pressure change.

Remove the hose of the low pressure side of manifold gauge.

6.Set a valve cork of liquid and gas service port to the open position.

Adding Refrigerant

Add refrigerant charge according to table below:

If you use a pipe longer than 4 m(24JFB) or

5 m(12/18/24JFC),A’g of refrigerant R-410A must be added for each extra meter.

If you use a pipe shorter than 4 m(24JFB) or

5 m(12/18/24JFC),The evacuating time is normal. Refer to the Service Manual for further details.

Outdoor unit

Indoor unit

 

Gas pipe side

 

Liquid pipe side

Outer

Torque

Diameter

N•m

kgf•cm

ø6.35 mm

14~18

140~180

ø9.52 mm

34~42

350~430

ø12.70 mm

49~61

500~620

ø15.88 mm

68~82

690~830

Manifold gauge

Valve

Gas service port <Low pressure>

 

Vacuum

Liquid service port

Pump

<High pressure>

(Backward flowing

 

prevention)

Model

A

 

 

12

10

 

 

18/24

20

 

 

07stIn llan atio

• The remaining air in the Refrigeration cycle, which contains moisture, may cause malfunction on the compressor.

• Always contact the service center or a professional installation agency for product installation.

English-49

MG_GOOD_R-410A_A3050_IB&IM_EN_DB68-05188A-00_UX.indd 49

2/17/2015 2:14:21 PM

Image 49
Contents Air Conditioner Features of your new air conditioner Contents English-4 Safety precautions01epPr aration English-5English-6 For UsingEnglish-7 English-8 Do not place objects or devices under the indoor unitEnglish-9 For CleaningOperation ranges Checking before useEnglish-10 English-11 Technical SpecificationsAR24JRFNCWK/MG English-12Main parts Checking the name of the partsDisplay English-13Remote controller buttons Checking the remote controllerEnglish-14 Low Battery warning Remote controller displayStoring the remote controller Inserting the batteriesBasic function Press the button to set the desired fan speed Press the button to adjust the temperatureEnglish-17 Vertical air flow Adjusting the air flow directionHorizontal air flow English-18Setting the On timer Setting the On/Off timerYou can adjust the fan speed in Cool/Fan/Heat ARJQ mode English-19English-20 Setting the Off timerButton Mode Additional options available in modeEnglish-21 English-22 Step cooling functionUsing the Comfort function Using the Fast functionEnglish-23 Press the Options buttonEnglish-24 Using the Single User functionPress the Single user button Setting the Beep sound Using the Auto Clean functionEnglish-25 Cleaning the indoor unit Cleaning the air conditionerSuch as thinner, kerosene and acetone etc. to clean Cleaning the outdoor unit heat exchangerRemoving the Air filter Cleaning the air filterEnglish-27 Remove the air filter from the main bodyEnglish-28 Reassembling the Air filterTop of the Air filter into the main body.. ➀ English-29 Maintaining the air conditionerAir conditioner TroubleshootingEnglish-30 Take the cover off and takeCheck the Drains have been cleared Regular Maintenance Button or disconnect the power plug/switchError is indicated Heard when refrigerant flow movement changes. It is normalEnglish-32 General informationInstalling the unit Choosing the installation locationPower supply line, fuse or circuit breaker Indoor unitOutdoor Unit Where sulfide gas existsEnglish-34 English-35 When installing more than 1 outdoor unitTop view Side view Accessories in the indoor unit case AccessoriesAccessories in the outdoor unit case English-36Optional accessories Fixing the installation plateTools required for installation General Tools Tools for test operationsEnglish-38 Assembling the hanger screwRemoving the screws This QR code for detail video of indoor unit installationRemoving the Cover panel Before mounting the indoor unit English-39English-40 Assembling the Cover panel After mounting the indoor unitCable specification Connecting the assembly cableConnecting the cable English-41Each wire is labeled with the corresponding terminal number Extend the assembly cable if necessaryEnglish-42 Smooth the cut edges English-43Cut off the remaining foam insulation TorqueCutting or extending the pipe Evacuating the indoor unitEnglish-44 English-45 English-46 Drain hose installationEnglish-47 Changing direction of the drain hoseCheck for leakage on both side of the drain outlet English-48 Evacuating the connected pipesConnect a drain hose to the drain plug Drain hole Drain plugEnglish-49 Adding RefrigerantIf you use a pipe longer than 4 m24JFB or If you use a pipe shorter than 4 m24JFB orCylinder with siphon English-50English-51 Performing the gas leak testsOuter Tightening torque 07stIn llan atio To check for gas leaks on the outdoor unitFixing the outdoor unit in place Outdoor unit installed on the wall by rackEnglish-52 English-53 Smart Install modeOff / Blinking / On English-54English-55 Final check and trial operationEnglish-56 Packing and unpacking guideEnglish-57 How to connect your extended power cablesAtio 021-8255 CE English-60

AR24JRFNBWKNMG, AR24JRFSBWKNMG specifications

Samsung is renowned for its innovation and quality in the electronics industry, and the AR24JRFSBWKNMG and AR24JRFNBWKNMG air conditioners exemplify this commitment. Designed for efficiency and comfort, these models are ideal for residential and commercial spaces, providing optimal climate control.

One of the standout features of both models is the inverter technology. This technology allows the air conditioners to adjust their cooling output based on the temperature of the room, ensuring energy efficiency and consistent comfort. By running the compressor at varying speeds, these units minimize energy consumption while maintaining the desired indoor environment.

The AR24JRFSBWKNMG and AR24JRFNBWKNMG also incorporate a robust air filtration system. Equipped with a multi-stage filter, these units effectively capture dust, allergens, and other airborne particles, improving indoor air quality. This is particularly beneficial for allergy sufferers or those living in urban areas with high levels of pollution.

Noise levels are another critical consideration for any air conditioning system. Both models operate quietly, thanks to their advanced design and technology. The noise reduction features ensure that the air conditioners can function without disrupting your peace, making them suitable for bedrooms, living rooms, and office spaces.

Additionally, Samsung has prioritized user convenience with smart features. The air conditioners can be controlled remotely via a smartphone app, allowing users to adjust settings from anywhere. This smart capability ensures that your space is at the perfect temperature upon arrival, maximizing comfort and ease.

Energy efficiency is further complemented by the inclusion of a high-efficiency compressor, which contributes to lower electricity bills. The models have received a high Energy Efficiency Ratio (EER) rating, making them not only eco-friendly but also cost-effective.

Moreover, both air conditioners come with a sleek and modern design, seamlessly blending into a variety of interior styles. The compact size is ideal for space-saving installations, enhancing the aesthetic appeal of any room.

In summary, the Samsung AR24JRFSBWKNMG and AR24JRFNBWKNMG air conditioners provide a combination of advanced technology, energy efficiency, and aesthetic design. With features such as inverter technology, smart controls, and exceptional air filtration, these units cater to the needs of modern consumers seeking comfort and reliability in their climate control solutions.