Troubleshooting
You may encounter an unexpected problem while using this system that makes it hard to use the system properly. In many cases, however, they are minor problems rather than serious flaws in the system.
Refer to the following tips for some possible solutions.
When power will not come on | • Make sure that the cord is | |
properly plugged in. | ||
| ||
| • Check the power cable. | |
|
| |
When the screen does not appear | • Check the connections with | |
| the camera, accessories and the | |
| external monitor. | |
|
| |
When record is not working | • Make sure the Video In port | |
| of the VCR and the VCR | |
| Accessory Video Out port of this | |
| system are properly connected. | |
| • Check if the tape inserted into | |
| the VCR is able to record. | |
| • Check that the REC Trigger Out | |
| port of the Time Lapse VCR is | |
| properly connected to the VCR | |
| Accessory TRIGGER (6PIN | |
| VCR ACCESSORY) port of this | |
| system when you record in the | |
| Time Lapse Mode. | |
|
| |
When playback is not working | • Make sure the Video Out port of | |
the VCR and the VCR Accessory | ||
| ||
| Video In port of this system are | |
| properly connected. | |
| • Check if the Display Mode of | |
| this system is in P.B. Mode or | |
| Triplex Mode. | |
|
|
When the screen does not appear in the Auto Sequence Switch Mode
•Check that the screen is in Live Mode.
•Check that the time of “SEQUENCE” under the SETUP MENU is properly set.
If the problem persists, contact the local sales representative or service center for support.
Note
If the problem is related to VCR recording or playback, check the VCR as well.