Eng-5 | Samsung SMO-150MP/UMG, SMO-150TRP manual

I. MENU

Display the Setup menu on the screen. Press it again to exit the Setup menu.

J. MULTISCREEN

Switches to the split screen view. Each press of this button changes to the 4, 8, and 9-split screen sequentially. Only the 9 and 16 split screens are available in the Triplex mode.

K. SEQUENCE

When pressed in the full screen mode, chan- nels are switched automatically and sequen- tially within a specified time period.

L. FREEZE

Captures the selected screen as a still screen. Refer to the section “When you want to watch in FREEZE screen mode” on page Eng-7.

M. PIP

Selects the Picture in Picture mode.

N. ZOOM

When pressed in full screen mode, the screen is enlarged. Each press of this button enlarges the screen two times sequentially and then returns to the normal size. Use the Rotary Wheel to move the Zoomed-in screen.

O. Number Key(0 ~ 9)

Press the number of the channel to watch it in full screen mode. Or, press the SYSTEM ID button and then press the number of the system you want to control with the remote control.

P.ZOOM(TELE/WIDE)

Only the remote control has this button. It is available only when a camera (SOC-420(P), SOC-920(P) sold separately), is connected to the system.

Q.FOCUS(FAR/NEAR)

Only the remote control has this button. It is used for camera Focus control and available only when a camera (SOC-420(P), or SOC- 920(P), sold separately), is connected to the system.

R.IRIS(CLOSE/OPEN)

Only the remote control has this button. It is used for camera Iris con- trol and available only when a camera (SOC-420(P), or SOC-920(P), sold separately), is connected to the system.

S.ONEAF

Performs Auto Focus for the selected camera once in the present sta- tus. Only the remote control has this button. It is only available when a camera (SOC-420(P), or SOC-920(P), sold separately), is connected with the product.

T.SYSTEM ID

Selects the system to control with the remote. Only the remote control has this button.

U.ID RESET

Located on the remote control, this button resets the selected System ID to the default ID (1).

Rear Panel

A. CAMERA IN(RJ-45)

Video camera input terminals. You can connect up to 8 cameras with RJ-45 connectors.

B. CAMERA IN (BNC)

Video camera input terminals. You can connect up to 8 cameras with BNC connectors.

Caution

Either RJ-45 or BNC type cameras should be connected to the same channel. Signal interference will occur if both types of camera are connected to the same channel.

C.VCR

•Connects to the VCR using a 6-pin connector.

•TRIGGER: Trigger output terminal for the VCR

•VIDEO IN/OUT: Video input/output terminal for the VCR

•AUDIO IN/OUT: Audio input/output terminal for the VCR

D.AUX

•Connects to another device using the 4-pin connector.

•SPOT VIDEO OUT: The terminal that allows you to supervise the specified channel within the Main screen on the additional connected monitor.

•SPOT AUDIO OUT: The terminal that allows you listen to the sound of the specified channel on the additional connected monitor.

•SLAVE VIDEO OUT: The terminal that allows you to view the Main screen displayed at the present time on the additional connected monitor.

E.ALARM

•A/O (HOT/COLD): When an alarm occurs, the Active Make signal is output.

•A/R: Connects to the Alarm Reset terminal of VCR. When an alarm is triggered, a pulse is output.

•G: Connects to the ground terminal of VCR.

F.~AC IN

Connects the power cord.