Samsung HT-D350K/XV manual Sound Edit, Setting up the Speaker Delay Time, Test Tone

Settings
Speaker Setting
Speaker Size			▶
Sound Edit
Delay Time
Test Tone	:	Off
Select			Return
Move	Select		Return

~For the Front, the mode is set to Small.

~For the Subwoofer, the mode is set to Present.

~For the Center and Surround, you can switch the mode to Small or None.

-Small : Select this when using the speakers.

-None : Select this when no speaker is connected.

✎NOTE

`The speaker mode may vary depending on the Dolby Pro Logic and Stereo settings.

Sound Edit

You can adjust the balance and level for each speaker.

Settings

Sound Edit

Front Bal.	dB L		R	dB
Surround Bal.	dB L		R	dB
Center Level				dB
Surround Level				dB
SW Level				dB
	<Change " Select ' Return
	mMove	" Select		' Return

Press the $% buttons to select and adjust the desired speaker.

Press the _+ buttons to adjust the settings.

Adjusting Front/Surround Bal.

`You can select between 0 and -6.

`The volume decreases as you move closer to –6.

Adjusting Center/Surround/Subwoofer Level

`The volume level can be adjusted in steps from +6dB to –6dB.

`The sound gets louder as you move closer to +6dB and quieter as you get closer to -6dB.

03

Delay Time	Setup
If the speakers cannot be placed at equal distances from
the listening position, you can adjust the delay time of the
audio signals from the Center and Surround speakers.
You can also set the Test Tone in this mode.

Setting up the Speaker Delay Time

When 5.1CH Surround Sound is played, you can enjoy the best sound if the distance between you and each speaker is the same.

Since the sounds arrive at the listening position at different times depending on the placement of speakers, you can adjust this difference by adding a

delay effect to the Center and Surround Speakers.

Settings
	Delay Time
		Front
		Center	:	00ms
		Surround	: 10ms
		Subwoofer
		Test Tone	:	Off

<Change " Select ' Return

mMove " Select ' Return

Test Tone

Settings

Speaker Setting

Speaker Size

Sound Edit

Delay Time

Test Tone : On ▶

" Select ' Return

mMove " Select ' Return

Use the Test Tone feature to check the speaker connections.

~Press the _+ buttons to select On.

~The test tone will be sent to Front Left ➞ Center

➞ Front Right ➞ Surround Right ➞ Surround

Left ➞ Subwoofer in order.

To stop the test tone, press the ENTER button.

English 21