CONNECTIONS
●● Before moving or installing the product, be sure to turn off the power and disconnect the power cord.
●● If the main unit is powered off, the wireless subwoofer will in standy mode and the STANDBY LED on the front will blink Red directly. (no blue LED).
●● If you use a device that uses the same frequency (2.4GHz) as the Soundbar near the Soundbar, interference may cause some sound interruption.
●● The maximum transmission distance of the wireless signal between the main unit and subwoofer is about 10 meters, but may vary depending on your operating environment. If a
●● If the main unit doesn't make a wireless connection, follow steps
●● The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and moisture.
●● For optimal listening performance, make sure that the area around the wireless subwoofer location is clear of any obstructions.
LED INDICATOR LAMP STATUS ON SUBWOOFER
LED | Status | Description | Resolution |
|
| Standby (with the Soundbar main | Check the power supply to the |
Red | On | unit turned off) | Soundbar main unit |
Connection failed | Connect again | ||
|
| (refer to the instructions on manual | |
|
|
| connection in the user manual) |
| On | Successfully connected | - |
| (normal operation) | ||
|
|
| |
Blue |
| Standby (with the Soundbar main | Check the power supply to the |
Blinking | unit turned off) | Soundbar main unit | |
| Connection failed | Connect again | |
|
| (refer to the instructions on manual | |
|
|
| connection in the user manual) |
Red and blue | Blinking | Malfunction | Contact the service centre. |
16