Step-by-step installation
STEP 1 Select a location
Location requirements:
• Solid, level surface without carpeting or flooring that may obstruct ventilation
•Away from direct sunlight
•Adequate room for ventilation and wiring
•The ambient temperature is always higher than the freezing point (0 ˚C)
•Away from a heat source
STEP 2 Leveling your washer
See if the washer is level by checking the position of the tub:
| 1. | Slide the washer into position. |
| 2. | Open the lid of the washer, and pour |
| ||
|
| the water into the tub to just below the |
|
| pulsator level. |
A | 3. | If the washer is level, the pulsator (A) is |
|
| positioned at the center of the water as |
|
| shown in the figure. |
English 13
Installation
WA8700K(NON-HEATER)_03804E-01_EN.indd 13
2/22/2017 3:55:48 PM