Installation
Installation
STEP 6 Running a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1.Load about 6 pounds of laundry into the tub.
2.Press POWER to turn on your washer.
3.Press Rinse+Spin on the Cycle panel.
4.Press and hold START/PAUSE to start the test cycle.
5.The washer should not rock or vibrate excessively when water is supplied or when washing or spinning, and should drain well during the spin cycle.
NOTE
If water leaks while water is being supplied or drained, check the water connections. Refer to the "STEP 3 Connect the water hose" section on page 14 for instructions.
NOTE
If the washer rocks and vibrates excessively, level your washer again. Refer to the "STEP 2 Leveling your washer" section on page 13 for instructions.
STEP 7 Calibration Mode
Your Samsung washer detects the laundry weight automatically.
For more accurate weight detection, please run Calibration Mode after the installation. To run Calibration Mode, follow these steps:
1.Remove laundry or any contents in the machine.
2.Press and hold Temp. and Delay End simultaneously for at least 3 seconds when the power is turned on.
3.Press and hold START/PAUSE to activate Calibration Mode.
4.The pulsator rotates clockwise and counterclockwise approximately 1 minute.
5.When Calibration Mode is finished, “0” appears on the display, and the washer automatically turns off. The washer is now ready for use.
20 English
2/22/2017 3:55:53 PM