Samsung SHR-3010P manual 6Alarm Record Setup

DIGITAL VIDEO RECORDER

GB GB

6Alarm Record Setup

➄ DISK END BUZZER	The following illustrates the intial setting of the ALARM RECORD SETUP menu.
If set to ON, the Buzzer will sound when the HDD is full during the recording; if set to
OFF, the Buzzer will not sound. [ON/OFF]		ALARM RECORD SETUP
		ALARM ENABLE	OFF
➅ RECORD TIME MARK		ALARM DETECT TYPE	N.O.
		ALARM BUZZER	ON
		MAIN ALARM TIME	10SECOND
If set to ON, the recording time will be displayed during playback; if set to OFF, it will not		PRE ALARM TIME LIMIT	2SECOND
		POST ALARM TIME LIMIT	OFF
be displayed. [ON/OFF]		MAIN ALARM PICTURE RATE	30.00FPS
		MOTION DETECTION	OFF
		SET AREA & SENSITIVITY
➆ STATUS DISPLAY
Set the location on the screen where the time of recording will be displayed during	① ALARM ENABLE
playback. Set to LEFT to display it on the bottom left of the screen, or set to RIGHT to
	You shall select ON to start recording in the event of alarming and select OFF to prevent
display it on the bottom right of the screen. [LEFT/RIGHT]
	recording in the event of alarming. If you set the ALARM ENABLE to ON and exit the menu,
	the system will begin recording whenever alarm occurs. To force stop the recording during the
	alarm recording, press and hold the STOP(■) button for 3 seconds. Then, the recording by the
	current alarm will be stoppted, and the alarm recording will not be performed for the next 5
	seconds even if alarm occurs. To completely stop the alarm recording, go into the menu
	within that 5 seconds to set the ALARM ENABLE to OFF. If no action is performed by the
	user for 5 seconds, the system returns to the alarm recording mode. [ON/OFF]
	② ALARM DETECT TYPE
	Set to N. C. (Normally Close) when the alarm input is Active High, and set to N.O.(Normally
	Open) when the alarm input is Active Low. [N.C./N.O.]
	➂ ALARM BUZZER
	Set to ON to have the system activate the Buzzer when a motion is deteced in the input
	video or when alarm occurs, or set to OFF to keep the Buzzer inactive. [ON/OFF]
	➃ MAIN ALARM TIME
	Set the duration for which alarm recording is to be performed when a motion is detected in the
	input video or when alarm occurs. The value can be set from 0 seconds to 5 minutes when you
	set to OFF. If you set to AUTO, the alarm recording is performed only during when the alarm
	signal is Active.
	[5MINUTE/4MINUTE/3MINUTE/2MINUTE/1MINUTE/30SECOND/20SECOND/
	10SECOND/AUTO/OFF]

3-17 3-18